Pro-Elec PELL0263 User manual

1
Stainless Steel Solar Path Light
Model: PELL0263
Please read these instructions carefully before use and retain for future reference.
IMPORTANT SAFETY INFORMATION
• Avoid locations of high temperature or humidity.
• The lamp is constructed to IP65 suitable for external use.
WHAT’S INCLUDED
• Lamp assembly x 4.
• User manual.
INSTALLATION
• Installation is simply embedding the spike in the ground
ensuring the solar panel is exposed for maximum charging
e󰀩ciency but not in the vicinity of other strong light source or
the low light illumination may not function.
• Remove the top cap by turning the lens then lift it o󰀨.
• Remove the insulating tab from the battery.
1.Unscrew the glass shell, unplug the insulating strip and use it
2.Unplug the insulation strip

2
SPECIFICATION
Solar panel: Polysilicon 2V, 160mA.
Battery: 1 x AA 600mAh Ni-MH rechargeable.
LED: 1 x SMD 3.0-3.2V 4800-5200K LED.
Working time: up to 6-8 hours.
Material: st steel + Glass construction.
Weight 0.66kgs.
OPERATION
• Allow at least 8hrs for the battery to fully charge initially.
NOTE: the lamp does not light except in low ambient light levels.
• When the ambient light falls below a preset level the LEDs will illuminate.
• During periods where the lamp may not be used such as in Winter, it is advisable
to charge the battery occasionally to maintain it’s performance and before re-using
the lamp.
• If the lighting performance reduces signicantly the battery may be getting aged
and not retaining it’s charge.
• To replace the battery remove
the top cap and switch the
light o󰀨 then unclip the battery
cover and remove the old
battery. Replace with a new
one of the same specication
noting the polarity and replace
the cover then ret the cap.
CLEANING & MAINTENANCE
• Clean the unit only with a damp cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
1.Unscrew the glass shell, unplug the insulating strip and use it
2.Unplug the insulation strip
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China
PO Box 13362 Dublin 2
PR2 9PP
Man Rev 1.1