
2
INSTALLATION
• Turn off or isolate the mains supply.
• Remove the two domed nuts on the mounting plate
and remove the wall mount plate.
• Offer the wall mounting plate to the wall in the
desired position with reference to the supply wiring
and mark the location of the 2 mounting holes.
Note: The cut out in the ange must go to the bottom
and the plate is marked UP.
• Drill the wall where marked taking care not to drill through hidden wiring or
pipework and t the wall plugs.
• Insert the supply wiring through the
grommet and place the mounting plate
against the wall and attach with the screws
into the wall plugs.
• The lantern diffuser may also be removed from the bracket if
required to aid visibility when making the wiring connections.