Pro-Ject Audio Systems Power Box RS Amp User manual

INSTRUCTIONS FOR USE
Pro-Ject Power Box RS Amp

© Pro-Ject Audio Systems · Pro-Ject Power Box RS Amp · Revision 2014.4.15
2
Dear music lover,
thank you for purchasing a Pro-Ject Audio Systems Power Box RS Amp.
In order to achieve maximum performance and reliability you should study these instructions for use
carefully.
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Safety instructions
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that
the voltage in your area meets the voltage requirements printed on the device.
Never handle the device while your hands are wet or damp.
Avoid letting liquids e
nter the device. Never place any item containing liquid, such as a flower vase
on or near the device. Never spill any liquid on the device or cables. Never place any naked flame
sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet
locations, next to a bathtub, sink, swimming pool or any other similar conditions.
Connecting Power Box RS Amp
Connect the power cable to the unitand to the mains. Then use special supplied cable to connect the
Power Box RS Amp with the amplifier(s). Then the original power supply of the amplifier is no longer
required.
Make all connections whilst the Power Box RS Amp is
switched off or disconnected from the mains
.
Power Box RS Amp is designed only for Pro-Ject Audio Systems products with 2x48V power supply.
Amp Box DS, Amp Box DS Mono, Stereo Box RS, Amp Box RS, Amp Box RS Mono
and for any future
product with 2x48V power supply. Products with different input voltage cannot be used with the
Power Box RS Amp.
!
!
!

© Pro-Ject Audio Systems · Pro-Ject Power Box RS Amp · Revision 2014.4.15
3
Connection to one amplifier
Any of listed Pro-Ject amplifiers
can be connected
Connection to two amplifiers
Connect only mono versions of the
amplifiers
Incorrect use
Power Box RS Amp is not designed
to drive two stereo amplifiers
Main power switch
The toggle switch on the left side will turn the unit on or off. The blue LED above the switch shows that the
unit is switched on.

© Pro-Ject Audio Systems · Pro-Ject Power Box RS Amp · Revision 2014.4.15
4
Technical specifications Pro-Ject Power Box RS Amp
Input voltage: AC 230V/50Hz IEC C15 connector (120V/60Hz US version)
Output voltage: two outputs by 2 x 48V / 2.5A DC each
Filtration capacity: 40.000 µF
Output voltage ripple: 7mV peak to peak
Dimensions W x H x D: 201 x 72 x 195mm
Weight: 4,8kg
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer
for further advice. Only if the problem cannot be resolved there, the unit should be sent to the
responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these
instructions for use. Modification or
changes to any part of the product by unauthorized persons
release the manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright ©2014. All rights reserved.
The information was correct at the time of going
to press. The manufacturer reserves the right to
make
changes to the technical specification
without prior notice as deemed necessary to
uphold the ongoing process of technical
development.