© Pro-Ject Audio Systems · Tuner Box S3 DAB+ · Revision 2023.07.14
Technical specifications Pro-Ject Tuner Box S3 DAB+
Tuning range FM-band: 87,5 - 108MHz (50kHz steps)
Frequency response: 20Hz - 20kHz
S/N ratio: 50dB
THD: 0,05%
Stereo separation: 30dB / ∆f 75kHz and f mod 1kHz
Sensitivity: 7dB/V mono, 17dB/V stereo /75 ohms
Antenna input: 1 x co-axial DIN-socket (75 ohms)
Digital output: 1 x coaxial SPDIF, 1 x optical SPDIF
Fixed Line-level output: 1 pair RCA sockets
WiFi Standards: WiFi 802.11 b/g/n
Headphone output: 1 x 6,3mm / 2x 75mW at 32ohm (1%THD)
Remote control batteries: 2x AAA 1,5V (not included in packaging)
Outboard power supply: 9V/1A DC, 110 –240V/50, 60Hz
Power consumption: <1W in standby
Dimensions W x H x D (D with sockets): 206 x 55 x 153 (164) mm
Weight: 940g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons, release the
manufacturer from any liability over and above the lawful rights of the customer.
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright ©2023. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
Waste from Electrical and Electronic Equipment (WEEE): This directive mandates the collection and recycling
of electronics and component materials in order to reduce the amount going to landfills. Outside North
America, when the user decides to discard this product, it must be sent to a separate collection facility for
recycling. Please contact your point of purchase for more details.
Federal Communication Commission (FCC) Interference Statement FCC Part 15: This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
