PRO SIGNAL PS-UTS3760 Manual

Universal Replacement Television Stand
Model PS-UTS3760
Assembly / User Manual
This universal replacement television base is intended for use
with televisions with a 60" diagonal screen measurement
or less, and weighing less than 50 pounds. Please note
that televisions differ greatly in size and weight distribution,
and no two installation circumstances are the same. It is
the user's responsibility to ensure the suitability of this product
for each individual situation.
Please read this document completely prior to use.
This completes the assembly steps for this stand.
t is the ultimate responsibility of the user to ensure the safe and secure
installation of any television on this stand. There is no guarantee that every television,
even if within the size and weight limits specified, will be secure in every situation.
Once the installation is complete, the user must make certain the television set is secure.
Failure to do so could result in property damage, electrical or fire hazard and personal
injury or death, should the television fall.
Things to remember:
Furniture including tables, dressers, entertainment and shelves must be tested
to ensure stability.
Televisions should be installed out of reach of small children or pets that could potentially
pull or knock a set from its location.
Connecting cables, including power cords, or satellite TV wires, cables
from other components, indoor antennae and similar items should be secured and tucked
out of the way to prevent them being snagged or tripped over.
Televisions should not be located in direct sunlight or in locations where they can come into
contact with rain or moisture.
In the event that the user is not confident in the safety of this installation it is
highly recommended that a qualified installation professional be contacted.

Identify and verify all of the included hardware
1
A(x1) B(x1)C(x1)D(x1) E(x1) F(x1)
(x4)
M-F
H(x1)
G(x8)
(x8)
M-G
(x4)
M-H
M5x14 (x4)
M-A
M6x14 (x4)
M-B
M8x20 (x4)
M-C
M6x30 (x4)
M-D
M8x30 (x4)
M-E
G
H
C
F
D
E
Step One:
Attach part
(F) to (C) using the
screws provided (G) for the right
stand leg. Attach part (E) to (D)
using the screws provided (G) for
the left stand leg. Tighten the
screws using the Allen key (H).
Step Two:
Attach the completed left leg of the
stand to bracket (B) using the screws
provided (G). Then attach the
completed right leg of the stand to
bracket (A) using the screws provided.
2
Tighten the screws using the Allen
G
H
Step Three:
With care, lay the TV face down on
a flat surface with a towel or blanket
covering the screen, in order to
keep it protected.
Carefully identify the screws that
match the fixing thread on the rear
of the TV.
WARNING: Ensure the appropriate
screw size (M-A, M-B, M-C or M-D)
for the TV is selected prior to
screwing the stand to the rear of
the TV.
Do not screw too far into the TV as
it may damage components.
Attach the TV stand to the back of
the TV using the appropriate screw
size and spacer if needed. Be sure
that the screw is tightened securely.
3
TV
TV
TV
M-A
M-B
M-C
M-F
M-C
M-GM-F
M-C
M-D
M-E
M-GM-F
M-HM-F
M
M
-
-
D
E
M-GM-F
M
M
-
-
D
E
M-H
or
Step Four:
Place the TV so that it is in an upright
position and check its stability prior to
moving it to its permanent location.
4