PRO SIGNAL ST03917 Manual

Universal Replacement Television Stand
Model ST03917
Assembly / UserManual
This universal replacement television base is intended for use
with televisions with a 39" diagonal screen measurement
or less, and weighing less than 30 pounds. Please note
that televisions differ greatly in size and weight distribution,
and no two installation circumstances are the same. It is
the user's responsibility to ensure the suitability of this product
for each individual situation.
Please read this document completely prior to use.

Identify and verify all of the included hardware
Step One:
1
H
Attach part
(F) to (C) using the screws provided
(G) for the right stand leg. Attach part (E) to (D)
using the screws provided (G) for the left stand leg.
Tighten the screws using the Allen key (H).
G
C
F
D
E

Step Two:
Step Three:
2
Attach the completed left leg of the
stand to bracket (B) using the
screws provided (G). Then attach the
completed right leg of the stand to
bracket (A) using the screws provided.
With care, lay the TV face down on
a flat surface with a towel or blanket
covering the screen, in order to
keep it protected.
Carefully identify the screws that
match the fixing thread on the rear
of the TV. WARNING: Ensure the
appropriate screw size (M-A, M-B,
M-C or M-D) for the TV is selected
prior to screwing the stand to the
rear of the TV.
Do not screw too far into the TV as
it may damage components.
Attach the TV stand to the back of
the TV using the appropriate screw
size and spacer if needed. Be sure
that the screw is tightened securely.
Tighten the screws using the Allen key
(H).
G
H
B
A
3
TV
TV
TV
M-A
M-B
M-C
M-D
M-E
M-D
M-E
M-F
M-E
M-D
M
M
-
-
F
F

Step Four:
4
Place the TV so that it is in an upright
position and check its stability prior to
moving it to its permanent location.

This completes the assembly steps for this stand.
It is the ultimate responsibility of the user to ensure the safe and secure
installation of any television on this stand. There is no guarantee that every television,
even if within the size and weight limits specified, will be secure in every situation.
Once the installation is complete, the user must make certain the television set is secure.
Failure to do so could result in property damage, electrical or fire hazard and personal
injury or death, should the television fall. Pro Signal, CPC, Premier Farnell and all retail
dealers providing this product cannot be held liable for damages that result from improper
or insecure installation.
Things to remember:
Furniture including tables, dressers, entertainment stands and shelves must be tested
to ensure stability.
Televisions should be installed out of reach of small children or pets that could potentially
pull or knock a set from its location.
Connecting cables, including power cords, cables, antennaeor satellite TV wires, cables
from other components, indoor antennaeand similar items should be secured and tucked
out of the way to prevent them being snagged or tripped over.
Televisions should not be located in direct sunlight or in locations where they can come into
contact with rain or moisture.
In the event that the user is not confident in the safety of this installation it is
highly recommended that a qualified installation professional be contacted.

Warranty
This device is warranted against manufacturing defects for a period of 1 year from the original date of
purchase. This warranty covers only the unit, and does not cover connected equipment, or any loss
that may occur, regardless of cause. It will be the sole discretion of CPC, Premier Farnell to
determine the applicability of said warranty, and determination as to whether the unit will be repaired
or replaced. Questions regarding application, use, or problems with this unit should be directed to
CPC, Premier Farnell Tech Support, which can be found at http://cpc.farnell.com.
Model ST03917