PROfit SLY User manual

GOGGLE SYSTEM AND LENS CARE
Your SLY goggle system has a dual polycarbonate lens that has been
treated with a Thermo-Cured Anti-Fog and an Anti-Scratch coating.
CLEANING
• Clean your lens within two hours of any contact with paintball residues.
Remove the lens to ensure that all lens and goggle system surfaces are
thoroughly cleaned. Do not attempt to separate the dual lens.
• Use only warm water to clean the lens. Do not use any other products
as they may contain substances that may weaken the lens. Change the
lens if it has come in contact with any chemical products or fumes.
• Use only a clean soft cloth to clean the lens. Avoid the use of substances
that could scratch or dull the lens, such as newspaper, paper towels,
dish towels or clothing. It is normal for the anti-fog coating on the inside
surface to go through a tacky phase while drying. To clean this surface,
pat it with a moist cloth and let it dry. Do not wipe the inside surface - it
will streak and you will have to clean the lens again.
WARNING!
Read and follow carefully the instructions and warnings contained
in these instructions. Failure to observe all the instructions and
warnings could lead to serious or permanent injuries. Remember
that your goggle system cannot offer protection in all situations.
• ALWAYS wear your goggle system when you are within or near
an area in which paintball markers are being used or when using
or handling a paintball marker.
• NEVER remove your goggle system in the playing area, even if
the lens fogs or gets dirty. If your goggle system accidentally
comes off, throw yourself on the ground and protect your eyes.
Tell the other players to stop shooting and ask the Referees or
one of the other players to help you leave the area with your
eyes covered.
• Before the beginning of the game, all paintball markers must be
chronographed to ensure that the speed of the paintballs does
not exceed 300 fps (91 m/s). Higher speeds could exceed the
resistance limits of your goggle system and lead to serious or
permanent injury. Do not play if the speed of the paintballs
exceed 300 fps, or if speed is not verified.
• ALWAYS observe the rules of safe play and the rules of safe
paintball marker handling.
WARNING!
Before each game, breathe on the inside surface of the lens. If it
fogs up, replace the lens before you use your goggle system or
use only a SLY approved anti-fog treatment. Do not use any other
substances on your lens.
STORAGE
• Ensure that your SLY goggle system is clean before storing it.
Protect the lens against impacts and scratches. Store your goggle
system in a cool, clean and dry place, far from chemical products
or fumes and protected from high temperatures.
LENS REMOVAL
WARNING!
Check the lens before and after use. Replace the lens after one
year of use, even if it seems to be perfect. Replace the lens
immediately if it shows cracks or if it has received a direct impact
from a ball shot from a distance of less than 10 feet (3 m).
• In rare cases, the mask may cause irritations and it should not be
worn by persons who are subject to dermatitis. Discontinue the use
of the goggle system immediately in case of irritation and consult
your physician.
WARNING!
Ensure lens is firmly in place before wearing the goggle system.
Do not make any modifications to your goggle system. Use only a
lens and accessories that have been approved for your specific
SLY goggle system. The retention strap is not an ear protector.
PROFESSIONAL FIT PAINTBALL GOGGLE SYSTEM
INSTRUCTIONS
REV060511

fig. 4
fig. 5
fig. 1
Step 2
fig. 2
fig. 3
Connect headbands to lens attachment buckles by inserting the
headband loop through the slotted opening on the buckle, and
securing with the post. (See fig. 1)
Insert the lens into the goggle system ensuring that the lens tabs
are securely in place.The lens should be tight against the
face of the goggle system. (See fig. 2)
Insert the lens attachment buckles into the ear-holes on the
side of the goggle system. (See fig. 3)
Place the anchor clip into the lens attachment buckle. The curved
side of the anchor clip should be toward the rear of the goggle system.
(See fig. 4)
Lock the anchor clip into place by pushing the lever down toward
the rear of the goggle system. Rotate dial into “LOCK” position. (See fig. 5)
Step 1
Step 4Step 3
Step 5
The stylized “ring”the “PROFIT” and the “SLY ” logos are
registered trademarks.The SLY goggle systems have several
patents pending.
SLY USA: 3305 E. Miraloma Ave #179, Anaheim, CA 92806, USA.
SLY EUROPE: 65, rue L'Abbé Lemire -62000 ARRAS, FRANCE.
Copyright 2011 SLY LLC. All rights reserved.
www.slyequipment.com
The rain guard (Vent Block) may be installed during rain, but should otherwise
not be used as it may limit ventilation.
In order for this goggle system to fit a variety of head sizes the straps
need to be properly adjusted. Place goggle system on head with brow
face foam resting just above eye brows and lower face foam on the arch
of your nose. Make sure the head straps are tight around the back of your
head by adjusting the 2 sliding adjustors. For models with a Chin Strap,
secure the strap by attaching both sides of the chin strap fastener and
tighten so there is no slack. If there is any gap between the face foam
and your face, any gap between the chin strap and chin, or any part of
your ears or chin/jaw protrudes from the mask area of the goggle system,
DO NOT wear the goggle system. Find a goggle system that fits properly
before using a paintball marker. This goggle system is NOT designed
and intended for children 12 years of age and younger.
GOGGLE SYSTEM FITTING INSTRUCTIONS
This goggle system provides Basic Coverage as defined in ASTM standard FI776.
This goggle system is designed to fit users age 13 and older.
This goggle system is suitable for use with all calibers of paintballs which meet ASTM
standard FI979.
This goggle system CE standards for paintball goggle systems
SLY ASIA: 4-29A, Zhonghui , No.2, Dongmen St., Xiaobian Ave
ChangAn Town, Dongguan City, Guangdong, China