Projoy Electric PEBS User guide

PEBS INSTRUCTIONS FOR
INSTALLATION AND OPERATION
Thank you for choosing PROJOY products.
Please read carefully before installation.
INSTALLATION
DISASSEMBLY
PROJOY PEBS products are mounted on standard din-rails and are suitable for 35mm standard din-rail
installation. No additional tools are required for installation. Simply push the product into the guide rail.
For operation, please hang the hook at the top of the bottom into the guide rail to make the product 30°.
Then, press the product diagonally downwards to snap the product into the guide rail, and the final
product will be vertical as shown in the right figure.
PROJOY PEBS products are quick-release design and can be easily disassembled with a single
screwdriver. The details are as follows:
First insert the screwdriver into the opening at the bottom of the product buckle, use the product as a
fulcrum, and then withdraw the buckle downward. When you hear a click, the buckle will automatically
stop at the fixed position, and the product is separated from the guide rail. The bottom of the product is
first separated from the guide rail to form an angle of about 30°, and then slightly raised, and the upper
hook is separated from the guide rail to take out the product.
Priority snapping
into the din-rail
Bottom buckle
Tilt down and pull the
bottom snap into the
din-rail, and then you
can hear a click

WIRING ABILITY
WIRING CIRCUIT DIAGRAM
Insert the screwdriver into
the opening at the bottom
and pull it down
Slightly lifted up so that
the buckle in the red
circle leaves the rail
Load
Load
Ungrounded system
Load
Single pole grounding system
Connection tool
Wiring capability(mm2)
Tightening torque(Nm)
2# screw driver
1.5-50mm2
2-3.5Nm
2nd Floor, Building 3, No. 2266, Taiyang Road,
Xiangcheng District, Suzhou
Tel : [phone]
Fax: [phone]
Web: www.projoy-electric.com
E-mail: [email protected]