Prompter People Universal Manual

Slide beamsplitter into frame.
Metal pull bar faces
up and out.
Universal Set-Up Sheet
Place Universal sled
mount on stand.
(Use tall stand for
standing talent and
short stand for
seated talent). Secure with thumb screw.
1
Place LCD on sled (control buttons should face towards rear).
Secure LCD with thumb screws.
2
Slide beamsplitter frame onto sled.
3
5
Rev: 070708
(Clean beamsplitter with included yellow microfiber cloth)
Secure Beamsplitter frame with
thumb screws (hand tighten only).
4
Completed assembly of teleprompter with camera.

Adjusting the Universal Teleprompter For Use
The Universal 15/17 includes two stands. The shorter stand is used for talent that is seated, and the taller stand
should be used for talent that is standing.
The Universal 15/17 is designed for relatively static shots. The cloth hood is flexible enough for panning and
tilting approximately 10-15 degrees.
For software set-up please refer to the Flip-Q set-up guide, or go to www.flip-q.com.
Rev: 070708
Put cloth hood around the lens
and tighten drawstring. Make sure
the camera is centered in frame.
Slide the camera behind
the Universal teleprompter.
The lens should be 1/2” - 1”
from the beamsplitter.
Loosen the thumbscrews and center
the LCD under the beamsplitter.
Make sure to tighten screws before use.