Propur ProMax PM100-IC User manual

FOR TECHNICAL SUPPORT PLEASE CALL
1-800-544-3533
OR email:
cus [e-mail]
Instructions
ProMax™ Inline Connect System
Inline Refrigerator/Ice Maker Filter Instructions

New Propur™ ProMax™ Inline Connect System
Model PM100-IC
1. Package Contents
a. PM100-IC filter assembly
b. Compression fittings attached)
c. Mounting clip and screw
2. Tools and Hardware Required for Installation
a. Adjustable wrench
b. Bucket
c. File
d. Rags
e. Pliers
f. Tube cutter
g. Saddle valve and 1/4” tubing if not currently installed) or for a new
installation-check your local hardware store for a refrigerator
installation kit.
3. Installation
IMPORTANT – TURN OFF REFRIGERATOR/ICE MAKER WATER
SUPPLY LINE BEFORE INSTALLING. SHOULD THIS BE A NEW
INSTALLATION, INSTALL SADDLE SHUTOFF) VALVE WITH
SUPPLY LINE TO REFRIGERATOR/ICE MAKER. THE PM-100-IC IS
FOR COLD WATER USE
ONLY.
!
Inlet
Outlet
Mounting Clip

a. The PM100-IC comes with compression fittings designed for 1/4”
tubing.
b. Select a suitable location for the PM100-IC filter such as behind the
refrigerator or beneath the kitchen floor basement).
Location should be easily accessible for replacement.
c. The filter splices into standard 1/4” copper or plastic refrigerator water supply
line. Place a bucket under the supply line when cutting to catch any residual
water that may drain out. Deburr both cut ends with file of the supply line
before installing the filter.
d. Attach the water supply line to the INLET side of the PM100-IC filter by
i. Slide nut onto inlet water line
ii. Slide brass compression ring onto tube
iii. Insert tube into inlet end of filter and tighten nut using backup wrench
so that fitting does not turn into filter)
e. Place the OUTLET of the filter into an empty bucket and slowly turn on the
water. Allow the filter to flush for 5-10 minutes or
until water is clear. This initial flushing allows for any carbon
particles to be flushed out of the filter before attaching to your refrigerator.
f. Once flushed, turn off water supply to continue installation
g. Connect the supply line going to the refrigerator to the OUTLET side of the filter
by
i. Slide nut onto outlet water line
ii. Slide brass compression ring onto tube
iii. Insert tube into outlet end of filter and tighten nut using backup wrench
so that fitting does not turn into filter)
h. Turn on water. Check for leaks, retighten fittings, if
necessary. DO NOT OVERTIGHTEN!
i. Use the mounting clip and screw to attach the filter to any nearby support to
limit stress on the tubing. Allow easy
removal for filter assembly replacement.
j. Write the installation date on the filter.
4. IMPORTANT
a. Maximum operating pressure is 125 psi. If pressure is anticipated to exceed
125 psi, use a pressure reducing valve, not
included.
b. Should you notice a difference in the taste of the water after use, please
replace the complete assembly. Filter and housing is one self-contained unit.
c. Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection.
d. PM100-IC Specifications
Maximum flow - .50gpm
Maximum pressure -125psi
For cold water use only
Minimum temperature -35° F
Recommended replacement-750 gallons or up to 9 months

PROPURTM LIMITED WARRANTY
Lincoln-Remi Group, LLC d/b/a Propur “PP”) sells its products with the intent that
they are free from defects. PP warrants to the original retail purchaser/consumer
that its products will be free of defects in material and workmanship under nor-
mal use for a period of 9 months for the ProMax™ 100 Inline Con-
nect Refrigerator/Ice Maker “Warranty Period”). PP will replace or repair any
product, at its sole discretion, during the Warranty Period. Any damage caused
by misuse or abuse; accident; improper installation; dropped product; failure to
provide recommended maintenance; transportation damage; neglect; environ-
mental conditions; or any other conditions whatsoever that are beyond the con-
trol of PP are excluded from this warranty. This express limited warranty shall be
the sole and exclusive warranty. ALL OTHER WARRANTIES, WHETHER EXPRESS OR
IMPLIED, INCLUDING BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MER-
CHANTABILITY, FITNESS OR FITNESS FOR ANY PARTICULAR PURPOSE OR ANY OTHER
POTENTIAL OBLIGATION ON THE PART OF PP WITH RESPECT TO PRODUCTS SOLD BY
PP ARE DISCLAIMED. EXCEPT FOR ANY EXPRESS WARRANTIES, ALL PROPUR PROD-
UCTS ARE SOLD “AS-IS”. PP shall not be held liable for any incidental, consequen-
tial or special damages of any sort whatsoever. The liability of PP is limited to the
original retail purchaser and to the repair or replacement of defective parts dur-
ing the Warranty Period. No refunds will be given at any time. The liability of PP
terminates upon the expiration of the Warranty Period or transfer of product
ownership.
To obtain warranty service on your Propur product, mail the product with your
dated sales receipt as proof of purchase, postpaid, to the following address:
Propur, 1200 Benstein Rd, Commerce Twp, MI 48390. NO C.O.D’s
This warranty provides you with specific legal rights. You may have additional
rights which may vary from country to country. Because of individual country
laws and regulations, some of the above limitations and exclusions may not ap-
ply to you.
V05252016