Prozeda NAVO User manual

navo
Room user terminal
Installation and operating instructions
English translation of the German original installation and operating instructions
Version: 1.0
September 2014

Declaration of conformity
EN
Table of contents
1 Declaration of conformity ....................................................................................... 2
2 Description ............................................................................................................... 3
2.1 O er iew ................................................................................................................................................. 4
3 Installing the room user terminal ............................................................................ 4
4 Connecting the user terminal .................................................................................. 5
5 Commissioning ........................................................................................................ 6
6 Technical ata .......................................................................................................... 6
1Declaration of conformity
The product was manufactured and tested in accordance with CE directi es and therefore
bears the CE mark.

2Description
The na o room user terminal enables the user-friendly operation of all compatible
Prozeda controllers from the li ing area.
Exact mirroring of the controller user interface permits the isualisation and remote
control of all controller settings, parameters and measured alues.
No software installation required.

2.1 Overview
➀

LCD. Mirrors the controller user interface. After 15 seconds the display changes
automatically to "Room temperature display" mode. This is the standard display until
a key is pressed again.
➁

4 operating buttons. The same functions as with the controller.
3Installing the room user terminal
Use suitable screws and dowels for fastening the user terminal.
Hang the room user terminal in the "key holes".
1
92 mm
2

4Connecting the user terminal
Communication interface
The room user terminal is connected to the controller ia a ProBusX interface.
When using products from the Regula family, check the correct polarity of connection
terminals "A" and "B".
Regula
Power supply
The supplied power supply unit is fitted with a lustre terminal. This enables you to
connect the power supply unit near the controller and to install the lines – bus line and
power supply line – to the room user terminal in the li ing area.
A
B
P12V
B
A
M
4

5Commissioning
Once the user terminal is connected to the controller and to the power supply,
initialisation will be performed automatically and the room user terminal will be
immediately ready for operation.
6Technical ata
Housing material
100% recyclable ABS housing
Dimensions L x W x D in mm
145 x 100 x 30
Protection class
IP20 according to DIN 40050, EN 60529
Operating oltage
Plug
-
in power supply unit:
AC 90 ... 260 V~ / 50-60 Hz
Input oltage:
12 V / 1.0 A
Power consumption
< 1 W
Interfaces
ProBusX communication interface
Display
Backlit LCD
Humidity
Max. 60 %
Ambient temperature
0 to +40
°C
Storage temperature
–
10 to +60
°C
1715BED001-10B-E