PST FM400 User manual

Smart Valve controller Manual
1、 Product Profile
Welcome to choose our company's WIFI smart valve controller,
This product has the characteristics of intelligence, low cost and
high reliability. It can be controlled by distance away, It adopts
WIFI international technology and is fully compatible with WIFI
networ .
2、 Product specifications
Power supply voltage 12V/1A
Communication technology WIFI
Frequency of communication 2.4g
Valve pressure 1.6 mpa
Valve specifications 4, 6, 1 inch, 1.25 inch
Close valve time 5-10 seconds
Open valve time 5-10 seconds
Torque 30-60 gf.cm
Application System IOS/android
Application Valve type Handle valve
3、 Installation Guide
① Install the brac et on the installation ear of the smart valve controller (screw is not tightened first).
② Fix the mounting brac et on the water pipe or gas pipe (as shown in the figure).
③ Adjust the position of the smart valve controller, so that the output axis of the smart valve
controller is in line with the axis of the "water/gas pipe" valve handle. (Fig.) Then tighten the screw
at both ends of the mounting brac et. After the installation of the smart valve controller, Manually
pull down the clutch pull ring, Swing The smart valve controller Transfer handle,Chec if the valve
switch is in place.
④ Tighten the screw of the smart valve controller handle clip according to the diagram
⑤ Connect the power adapter of 12V/1A.

4、 Guidelines for Use
① Scan QR code, download "Smart Life" APP, Install and apply the APP, prompt the registration
account according to its instructions.
② Add equipment: Clic add+, Select the other equipment, press on top of controller for about
5 seconds until the indicator light flashes quic ly, Then the smart valve controller enters the pairing
networ state, according to the prompts to input WIFI password and other operations until the
pairing is successful.
③ The default state of the valve controller after pairing is closed , the controller can be switched as
needed. When the controller is opened, the indicator light is always on .Otherwise, When the valve
is closed, the indicator lights is off. You can manually press the button to switch the valve,
or you can use the mobile phone APP to switch the valve. The product has setting functions such as
timing, sharing and lin age. Please read the description of APP in detail to use the product.
④ After successfully pairing, if the button is pressed about 5seconds again, the LED indicator light of
the smart valve controller will flash quic ly, the original pairing information will be deleted, and the
pairing process will be carried out again. If multiple mobile devices are required to control the smart
valve controller, the sharing function of APP is adopted and allocated to multiple accounts.
⑤ In the absence of WIFI , The controller can control the valve to open or close by pressing the button ,
When the state of the smart valve is closed, it opens after the ey, Otherwise when the valve is
opened, it closes after the ey. When the power is cut off, the pull ring under the smart valve
controller can be manually pulled down and swing The Transfer handle to close or open the valve.
5、Failure Guide
① The valve controller switch is not in place:
Chec whether the smart valve controller axis center and the valve center axis are in the same axis.
if not in the same axis, not only ma e the valve switch not in place, but also burn the smart
valve controller ’s motor.
② The valve switch is stuc :
you can pull down the clutch pull ring and Swing The smart valve controller ’s handle with 90
degree until the valve can be switched smoothly. If the valve is too tight, it is recommended to
replace the valve.
③ The smart valve controller can not be paired into the networ :
Chec the WIFI signal is OK, And when the smart valves controller is pairing into the networ ,
please eep it as close to the router as possible.
④ For other troubleshooting problems, please read the APP’S help center in detail.