Puluomis US-AS003-X User manual

SMART BATHROOM
CORE TECHNOLOGY
SMART TOILET
U S E R G U I D E
Thank you for using this product，To make it
easier for you to use this product correctly.
Please read the User's Guide carefully and keep
all the information in a safe place.
The pattern is for reference only

Safety Precautions / Precautions
CONTENTS
/02
Name of each part /03
Annex /04
Instructions /05
Terms and Conditions /06
Cleaning and maintenance methods /07
Installation Notes /08
Technical indicators /10
Apply for repair confirmation /11
Warranty card /12
In order to allow you to use this product correctly,
please read this manual carefully.
If you have any questions, please contact your local dealer or agent.
【The rated voltage of this product is 110V（220V）, be sure to confirm before use】
1

SAFETY PRECAUTIONS / PRECAUTIONS
2
50Hz/60Hz5.身体、感知、智力能力缺陷或经验和常识缺乏的人（包括儿童） 应在有 监护人情况下使用，严禁儿童玩耍本器具。
1300W
4. 请使用可以负荷1300W（1600W即热款以下同）的插座.
For the safety of you and others, to avoid unnecessary harm and loss, please strictly follow
the following tips to properly use this product.
Warns you how to avoid personal injury.
Indicates that you must observe or avoid some operation to prevent damage to the
equipment or other items.
WARNING
MARK DESCRIPTION
ATTENTION
禁止拆卸
Do not disassemble
Must be obeyed
Must be obeyed
WARNING
This figure shows [forbidden]. Left shows [Do not disassemble].
This diagram shows the content that is mandatory.
The figure on the left shows[Must be obeyed].
Do not disassemble, repair or modify the product yourself, otherwise it may cause
malfunction.
Do not pour water or detergent on the product body or power plug,
as this may cause electric shock or malfunction.
Do not use a wet hand to plug the power plug, it may be an electric shock.
Make sure the water used is clean. Water pressure in line with the requirements.
1. This product is an electrical product, do not place it in a place where it is easy to be
sprayed or moist.
2. Make sure that the product's power outlet must be 110V（220V） / 50Hz / 60Hz.
3. The product's power outlet must be grounded.
4. Please use a socket that can load 1000W(1600W).
5. Remote control battery with three 1.5V dry batteries.
1. Do not step on the body and seat cover.
2. Do not use banana water, gasoline, pharmaceuticals and detergents or insecticides to wipe the product.
3. For a long time sitting only on the toilet, please adjust the temperature to low, to avoid the end of
the temperature burns.
4. In the product is not water supply, do not reverse the product, will cause the heating tube dry failure.
5. Persons with physical, perceptual, mental deficiencies or lack of experience and common sense
(including children) Guardians use the case, is strictly prohibited children play the device.
ATTENTION

NAME OF EACH PART
3
PANEL DESCRIPTION:
Notice label
Potty cover
Female special cleaning nozzle
Buttocks cleaning nozzle
sensory switch
Warm air
Power plug
control panel
Insulation seats

4
Accessory
Three-way, 2 pieces of expansion, 2 pieces of expansion column,
black gasket, fixed floor, stainless steel pipe, user manual.
Three-way expansion expansion column
black gasket fixed floor PE water supply pipe
user manual

5
INSTRUCTIONS
Key operation panel instructions
stop
Pressing the stop button during use will stop running.
When you get up from the toilet seat, it will stop automatically.
Hip cleaning
Press the wash button, run for 1 minutes will automatically stop.
When the button is pressed again at run time, the nozzle moves back and forth to clean more parts.
During operation, press the strength button to adjust the strength of the flushing water potential.
Female special cleaning / moving
Press this button to run for 1 minutes and then stop automatically.
When running this button, the nozzle will move back and forth to clean more parts.
During operation, press the strength button to adjust the strength of the flushing water potential.
Warm air drying
Press this button to start the heater drying function, about 3 minutes will automatically stop.
Running in accordance with the strength of the button temperature will be low temperature - medium -
high four files gradually change.
Fully automatic
Press this button to run the auto-cleaning function (run automatically in "Cleaning function -
Move function - Hair function")
Will help
Press this button to stop the function, and the [Stop] key can be stopped during the
extension of the spray bar.
Strength (warm air temperature cleaning strength)
Buttocks wash outlet outlet, water pressure for the high-grade, water thin and urgent. Use this
button during the use of personal hobbies, in the clean water can change the strength of change.
In the drying, press this button to adjust the temperature of the hair, the fourth gear adjustable
(room temperature / low / medium / high)
Forward and backward
This key for the spray bar before and after the adjustment key, when the original value of the
mid-range out, in the use of cleaning process by the forward spray bar can be extended on the
basis of the original value of 5mm; press the back button to the original value of the Based on the
return 5mm. Forward 2 files adjustable, adjustable back 2 files.
Water temperature
This key is the water temperature adjustment key,
Water temperature is divided into: room temperature / low temperature / medium temperature /
high temperature, four gear cycle, according to their own preferences to adjust.
Seat temperature
This key is the seat temperature adjustment key,
Block temperature is divided into: room temperature / low temperature / temperature /
high temperature, four gear cycle, according to their own preferences to adjust.
Energy-saving
This key for the power button, power saving indicator light, enter the power saving mode
power supply
This key is the power on / off key

6
Terms and Conditions
There is water left around the nozzle Radio, TV feeling noise
At the beginning of use, the warm
air may be slightly smell
Saving function
When exposed
Attached to the induction window
Slowly close the toilet seat and cover it
Just sitting in the toilet seat and cleaning process,
the nozzle may be around the water, which is the
product in the design needs, not a malfunction.
This product may interfere with the reception of radio and
television signals. In this case, move the radio and TV to
an undisturbed location.
This product in the beginning of the use of the use of
drying function will feel a little smell, and soon after this
smell will disappear.
The following operations can effectively save energy.
Do not blindly set the temperature of the toilet seat and
warm water too high,
Should be adjusted to not affect the comfort level is better.
Please combine spring and summer autumn and winter
temperatures for temperature adjustment.
Try to use the power saving function.
Turn off the power when you are away for a long time.
When freezing is possible, take antifreeze measures.
As the room temperature and toilet seat, cover the
surface temperature difference or humidity reasons, the
seat, will cover the surface of the water droplets
(condensation).To prevent condensation, please fully
ventilate and wipe with a dry cloth when condensation
occurs.
The dew will leave traces of the ground or damage the
ground.
In addition to the above, if there is more than water,
close the water supply angle valve, remove the
power plug from the outlet, and contact the
purchased or after-sales service department by
telephone or fax.
When you do not sit on the toilet seat, even if the
key press the key, cleaning water will not be ejected,
because this product is equipped with induction
window, so do not sit on the toilet seat, the buttocks
cleaning, female special cleaning, Drying and other
functions do not work. In addition, when the cover is
put on the coveror the cover is covered, the
unsuitable cover will cause the seating sensor
window to be operated or not to run.
Sitting on the toilet seat when the power outage,
even if immediately restore the power supply,
but also the function of hips and other functions
do not run, then, please get up from the toilet seat,
1 to 2 seconds and then sit down.
In order to prevent the toilet seat and toilet cover
suddenly closed, this product has a slow down
function, so that it can slowly shut down.
Please note that forced shutdown will cause a
malfunction.

7
CLEANING AND MAINTENANCE METHODS
Daily cleaning and maintenance
Toilet seat, cover, protective cover (plastic parts) cleaning and maintenance methods
Wipe with a soft, soft cloth
If you can not remove the dirt in time, it will become difficult to clean.
You can often wipe the dirt with a soft wipe. In addition, scrubbing
with water can prevent the generation of static electricity.
Static electricity can cause dirt to stick and black.
ATTENTION
ATTENTION
Do not use chlorinated cleaning agents, acid cleaners, disinfectants
when cleaning and maintenance.
Doing so may cause the product to malfunction or damage.
Please do not use a dry cloth or toilet paper to wipe.
Otherwise prone to scratches.
About antibacterial parts
Nozzle, toilet seat, cover the use of antibacterial resin, the operation of the switch panel
using antibacterial film.
WARNING
Do not sprinkle or clean the toilet seat
and the power plug.Otherwise it is easy
to cause electric shock, fire.
ATTENTION
PROHIBIT WATERING FORBIDDEN
When cleaning and maintaining plastic
parts, do not use unsuitable cleaning
agents (such as toilet cleaning agent,
household cleaning agent, bleach,
benzene, paint thinner, decontamination powder,
cresol).Otherwise the plastic part of the crack will
cause personal injury, electric shock, causing a fire.
When cleaning and maintenance, you must press
the power button to confirm that the power indicator
is off.When the nozzle is being cleaned, proceed with
the power supply.

8
Installation Notes
Installation step 1
TIPS
You will be used:
Remove the old toilet cover and wipe the
toilet clean. Remove the expanded stud
screw and insert the rubber into the toilet
bowl.
Will be fixed floor, stainless steel regulator,
stainless steel gasket and expansion of the
corresponding column hole in turn put.
Will lock the stainless steel screws, the
initial do not twist too tight, will be fixed
around the bottom of the floor position,
the stainless steel screws tightened,
let it not shaking.
When the main body
cover is separated from
the ceramic, the hands
are held on both sides
of the main body and
lifted upwards, pulled
out and the removal
method is shown.
Be sure to turn off the power and
water before disassembling
When the main body cover is mounted
on the toilet, the other side of the main
body is held in one hand and the other
hand is slowly pushed in parallel until it
is advanced.
Prepare before installation
Please be sure to follow the instructions in the
correct installation, please check the parts before
installation accessories as follows:
Disassembly
method

9
Installation Step 2. You will use:
① This is the toilet water tank, located
in the back of the toilet, the first water
valve closed, then the angle valve
preparation hose removed, the three
links and angle valve connection.
④ Connect the "water pipe" to the inlet
of the toilet bowl.
② And then the other end of the water
pipe connected to the three-way water
hole to complete!
③ Place the disassembled hose at the
other end with the tee, tighten with a
wrench.
1. When the inlet pipe is installed,
remember to turn the corner back on.
2. After the toilet cover body and inlet pipe
are installed, please take water first - after
power. 3. To remove the main body,
please close the angle valve and then
remove the power, and then reverse the
steps of the water pipe can be operated.
Explain：
This step is to allow the toilet to turn on
the water to prepare the front, like the
tap water half to the microcomputer
toilet! So that there will be covered with
clean water.
Connect the water pipe to open the
angle valve in case of new nozzle
nozzle, please plug in the power supply
it will automatically reset the nozzle will
stop the water.
Tips：
Please pay attention when
the main body and the water
pipe are installed

10
0.4L
5
WARMTH: IF YOU HAVE ANY CHANGES, YOU WILL NOT BE NOTIFIED.50Hz/60Hz
110V（220V）
3.如有电源线损坏请联系当地经销商或我公司售后服务部。45WWind 250Wtemperature32-48℃1.5m0.8L/分0.95L/分
3336°
WARNING
1. Smart toilet accessories factory has been deployed, is strictly prohibited unauthorized
disassembly, if any questions, please contact the local dealer or my company after-sales
service department.
2. All contents of this manual are based on the latest information on the product at the
time of printing. The Company reserves the right to make changes without notice.
3. If the power cord damage, please contact the local dealer or my company after-sales
service department.
TECHNICAL INDICATORS
specification
Water supply Way Connect directly to the water pipe
Temperature switch, temperature fuse, water level sensor
Use pressure
Butt wash water
Female cleaning water
Water tank capacity
Temperature adjustment
Room temperature / low temperature of about 33 ℃ / medium
temperature of about 36 ℃ / high temperature of about 40 ℃
Room temperature / low temperature of about 33 ℃ / medium
temperature of about 36 ℃ / high temperature of about 40 ℃
Heating power
Heating power
Heating power
Safety devices
Safety devices
Safety devices
Other safety devices
Power cord length
Temperature adjustment
Temperature adjustment
Cleaning device
Seat heating
device
Heater drying
heating device Temperature fuseTemperature insurance deviceleakage protector
1000W(1600W)
1000W(1600W)

11
APPLY FOR PRE-MAINTENANCE CONFIRMATION
SYMPTOM COUNTERMEASUREINSPECTION METHOD
Do not start at all
Whether the power outage or
the power outlet is not
connected
Whether the water is closed
or the water supply valve is closed
Whether the water supply filter
is blocked
Whether the water spray is blocked
Is the water supply pipe connection
tightened?
Water temperature, seat ring
temperature is transferred to room
temperature
Leakage
Water temperature,
seat ring cool
Flush no water or
poor water
Make sure to plug in the power plug
Unplug the power plug and reinsert it
Please clean the filter
Please check the water supply to
open the water supply valve
Please use a toothbrush to clean the nozzle
Please tighten the water supply pipe
connection
Please re-adjust the temperature

SMART BATHROOM
CORE TECHNOLOGY