Pure Enrichment PureDry PEDEHLRG User manual

OPERATION MANUAL
READ BEFORE USING
Model: PEDEHLRG
PureDry
Deluxe Dehumidier

2 3
TABLE OF CONTENTS
WARNINGS & PRECAUTIONS ……………..…………………................. 4
PRODUCT SPECIFICATIONS .........…...…...…........…............................…... 5
INTRODUCTION & PRODUCT DIAGRAM..………………………………………6
OPERATING INSTRUCTIONS………………………………........…………….7
REMOVING THE WATER TANK………...………….………………................... 8
CLEANING & STORAGE………...………….………………................…........ 8-9
WARRANTY & PRODUCT REGISTRATION………...........…….................... 10
TROUBLESHOOTING………...................................…….................... 11

1
WARNINGS AND PRECAUTIONS
Read the entire instruction manual before operation. Failure to adhere
to the following warnings can cause harm to you or the product.
●This product is intended for indoor household use only and not for
commercial, industrial or outdoor use.
●Close supervision is necessary when any appliance is used by or near
children and pets.
●This product should be kept in an upright position at all times to avoid
damage. Always place on a level, at surface during operation.
●Check the household voltage to ensure it matches the product's rated
specication before operating.
●Ensure that the air inlets and outlets are not blocked or covered.
●Never place anything on top of the product. DO NOT cover with any kind of
material while in use.
●DO NOT place the product too close to curtains or other objects. Allow at
least a foot of space between the product and other objects.
●DO NOT operate the product with a damaged cord or plug, after it
malfunctions or after it has been dropped or damaged in any way.
●DO NOT switch the product on when the water tank is full or when the
product is upside down.
●To prevent electrical shock, DO NOT spray the product, plug or cord with
liquids. Never submerge any part of the product in water.
●Always unplug the product when not in use or when moving location. To
disconnect from the power supply, grip the plug and pull from the power
socket. Never pull by the cord.
●Never unplug the power cord with the product turned on.
●DO NOT run the power cord under carpeting, or cover with rugs or runners.
Arrange the cord away from areas where it may be tripped over.
●Where possible, avoid the use of an extension cable as it may overheat
and cause a risk of re. Only use an extension cord after ensuring it is in
perfect condition.
●Never operate or store the product in direct sunlight.
●Always empty the water tank before storing the product.
●DO NOT attempt to repair or adjust any electrical or mechanical functions
on PureDry. Doing so will void the warranty. The inside of this product
contains no user serviceable parts.
5
PRODUCT SPECIFICATIONS
Dimensions: 9.1” L x 5.4” W x 12” H
Tank Capacity: 1.5L
Power: 100-240V, 50/60Hz, 80W
Weight: 5 lbs
Absorption Rate: Approx. 20 oz per day*
*Absorption rate may vary depending on room temperature and relative humidity. Estimate
is based on 86⁰ F and 80% relative humidity.
4

2 3
INTRODUCTION
Thank you for purchasing the PureDry Deluxe Dehumidifier by Pure
Enrichment. This product is the perfect size for removing excess moisture from
medium-sized rooms, closets and bathrooms. The product diagram below
details all of the components you will nd inside the box.
PRODUCT DIAGRAM
6 7
PRODUCT DIAGRAM (CONT'D)
OPERATING INSTRUCTIONS
1. Properly position the product in the room to be dehumidied by placing
it on a at, level surface. Take care to ensure there is no obstruction
blocking the airow into the air inlet and dry air outlet.
2. Plug the AC power cord into an electrical outlet.
3. Push the Power Button to turn the product on. The power light will turn
blue to let you know the product is working.
4. To adjust the rate of dehumidication, press the Low/High Speed Button
until the setting you want illuminates. The "L" light will illuminate when
the product is on low. The low setting is ideal for rooms with low to
medium humidity levels. The "H" light will illuminate when the product is
on high. Use this setting for rooms with high humidity levels.
5. Use the Timer Button to set a 4-hour or 8-hour timer. This feature shuts
the product o󰀨 automatically after the selected time has elapsed. If no
timer setting is selected, the product will run continuously until you turn it
o󰀨 or the water tank is full.
1. Timer Button
2. Power Button
3. Low/High Speed Button
4. Air Intake
5. Rubber Feet
6. Water Tank Window
7. Side Air Outlet
8. Easy Carry Handle
9. Back Air Intake
10. Removable Water Tank
11. Power Cord
12. Floater
13. Reservoir Cover
14. Hose Hookup

4 5
REMOVING THE WATER TANK
When the water tank is full, the product will automatically power o󰀨 and the
power light will turn red to let you know it's time to empty the water tank.
• To continue using the product, turn it o󰀨, remove the water tank,
and empty it. Place the tank back inside the product. Turn it on.
• DO NOT re-use or consume the water collected in the tank as it
may contain germs, bacteria, fungi, and microorganisms.
CLEANING & STORAGE
Before cleaning the product, turn it o󰀨 and unplug it from the electrical outlet to
prevent electric shock or accidents.
8 9
CLEANING & STORAGE (CONT'D)
Cleaning the Exterior of the Product
• Use a soft cloth to clean the surface of the product and a cotton
swab to wipe the dust from the grill of the air intake and air outlet.
• Clean only the exterior of the product. Attempting to clean the
inside of the product may cause product damage or electric shock.
Cleaning the Water Tank
• Remove the water tank and empty any collected water in the
kitchen or bathroom sink.
• DO NOT re-use or consume the water collected in the tank as it
may contain germs, bacteria, fungi, and microorganisms.
• Place the water tank and water tank cover under warm running
water. A soft cloth and mild dish detergent may be used to clean
away any residue. Thoroughly rinse away any dish detergent.
• Use a soft towel to dry the water tank and water tank cover or let
them air dry before placing them back into the dehumidier.
Cleaning the Back Air Intake
To clean the back air intake, use a
screwdriver to unscrew it from the
unit, then use water to wash it.
Dry it completely before screwing
it back on to the unit.
Storing the Dehumidier
1. Empty and clean the water
tank. Wipe it dry with a
clean, dry cloth, and reinstall it into the product.
2. Pack the dehumidier into a box or its original packaging to keep
dust from collecting on the product.
3. Store in a cool and dry place.

1110
WARRANTY
PureDry comes with an industry-leading 5 Year Warranty that begins on the
date of purchase.
The warranty applies to the dehumidier and necessary parts and labor
relating thereto. The warranty does not apply to damage resulting from
failure to follow the operating instructions, accidents, abuse, alterations or
disassembly by unauthorized individuals.
PRODUCT REGISTRATION
To ensure your full warranty and to receive product updates and streamlined
customer support, remember to register your product at:
www.pureenrichment.com
ARE YOU 100% SATISFIED?
If you have product questions or concerns don’t hesitate to contact us directly
at:
[email protected]
Pure Enrichment has an award-winning warranty, exchange, and customer
service program that guarantees hassle-free solutions to any issue you might
have within 24 hours!
Problem Probable Cause Solution
Product is not
powering on
Power cable not plugged
in
Plug in power cable
Household circuit
breaker
Reset your circuit
breaker. If necessary,
contact a licensed
electrician.
Product is damaged or in
need of repair
Stop operating and
unplug the power source.
Contact Customer
Service for assistance.
The water tank is full
or the tank is not put in
correctly.
Empty the water tank and
put it back, or reinstall
the tank correctly.
Product stops de-
humidifying/
No air comes out from
air outlet.
Fan has overheated
causing the product to
stop operation.
The product will start
working automatically
when the fan has cooled
down.
Air intake or air outlet is
blocked.
Remove any blockage
from the air inlet or outlet.
Too Noisy Product is not on a stable
surface.
Move the product to a
stable, at surface.
TROUBLESHOOTING

8
Santa Ana, CA 92705
www.pureenrichment.com