4 5
KNOW YOUR PUREIT MARVELLA RO™
1 Tap
2 Indicators
3 Micro Filtration (MF) Membrane
4 RO Membrane
5 Post-Carbon Sediment Filter
6 Post-RO Carbon Filter*
7 Pre-RO Carbon Filter
8 Pump
9 Low Pressure Switch
10 Solenoid Valve
11 SMPS
12 Control Circuit
13 Storage Tank
14 Pre-Sediment Filter
15 Waste Water Tube
16 Cleansing Solution Dispenser
17 Inlet Water Tube
18 TDS Modulator (Optional)
1 Cleaning solution dispenser
2 Power indicator
3 Storage tank indicator
4 GKK-1(Carbon & Sediment Filter)
life indicator
5 GKK-2 (RO Membrane) life indicator
6 Storage tank
7 Tap
8 Sediment Filter assembly
9 Inlet tube
10 Ball Valve Assembly
11 Ball Valve
12 Waste water pipe
TECHNICAL SPECIFICATIONS OF
PUREIT MARVELLA RO™ PURIFIER#
Pureit Marvella RO™
Height 488 mm
Width 360 mm
Depth 294 mm
Weight of ‘Pureit Marvella RO™’ 7.8 kg
Flow rate* Approximately 9 –12 litres per hour
Storage tank capacity 10 litres
6 Stage Purifying Technology
PP Melt Blown Pre-Sediment Filter, Pre-RO Carbon Filter,
Post-Carbon Sediment Filter, Reverse Osmosis Membrane,
Micro Filtration Membrane and Post-RO Carbon Filter
Membrane type Thin film composite spiral wound
Pump type Diaphragm pump, 24V DC
% Recovery* Typically 25%
TDS reduction** 90% (min)
Input water pH range 6.5–8.5
Power rating 36 Watts
Pressure rating 5–30 PSI***
Input Voltage 100-300VAC, 50-60 Hz
Material of construction for plastic parts Food safe, non-toxic, engineering grade plastics
Length of Power adaptor 1.8 metres
Total Dissolved Solids Upto 2000 mg/lit
Total Hardness 500 mg/lit (max)
Iron 0.3 mg/lit (max)
Turbidity 1NTU (max)
Germkill KitTM
Material of construction Food safe, non-toxic, engineering-grade plastics
GKK-1
Pre-Sediment Filter – 2 Nos
Pre-RO Carbon Filter – 1No
Post-RO Carbon Filter – 1No
GKK-2
Pre-Sediment Filter – 2 Nos
Pre-RO Carbon Filter – 1No
Post-RO Carbon Filter – 1No
Post-Carbon Sediment Filter – 1No
RO Membrane – 1No
Micro Filtration Membrane – 1No
Germkill performance standard Meets stringent international criteria for microbiologically
safe drinking water – e.g., Environmental Protection Agency (EPA), USA
* Permeate flow rate and recovery are based on standard test conditions and may vary depending on input water quality,
TDS, pressure and life of Filter elements.
** Input water quality and TDS content are important determinants of output water quality.
*** If input pressure exceeds 30 PSI, please install a company provided pressure reducing valve at an additional cost. If the
pressure is lesser than 5 PSI than you need to buy ‘Pressure enhancing pump’ at an additional cost. Device should not
be installed in a house where input pressure is greater than 60 psi.
#Technical specifications are subject to change or improvement without prior notice.
* Post-RO Carbon Filter fitted in the device may need to be changed intermittently at extra cost in case you face smell issues.
