INSTALLATION
Connecting Speakers
1. Use the wire on the back of the speaker in the output
tab of the amplier (or radio ampliers). The standard
colors on the terminals are red Positive (+) and black
Negative (-). Connect the red wire of the amplier to
speakers (+) tab. Connect one end of the black wire (-) to
the other tab. Connect each speaker to make sure that is
not (+,-) inverted polarity. If the polarity of the speakers is
reversed, the sound will be unnatural and will play
without bass.
2. There will be a prompt sound when BT is connected.
3. Since there is no priority set in audio input, please don’t
use BT and line in inputs simultaneously, otherwise
sound is mixed.
Stereo Connection
Rear Panel Specication
Remark
4. LOOP: Signal output, connect to active ampliers.
5. SUB: Bass output, connect to active ampliers
(SUB amplier is better).
6. Speaker Output: Connect to passive speakers.
7. LED Indicator: During power ON mode, light is constant
blue color; During power AUTO mode, lights goes o
when there is no signal input and it turns to blue color
when signal comes.
11. Power switch: When this switch is on Auto position, the
amplier will automatically turn on when a signal is
present and it will go standby when there is no signal
input.
Under power Vs. Over power
1. Most speaker damage is caused by ampliers with too
little power (wattage).
2. An overdriven amplier clips the waveforms and leads
to speaker distortion.
3. Clipping is usually audible and it may vary from harsh
sound to a fuzzy or unclear sound.
4. If you hear the clipping at high volume levels, turn down
the volume until the distortion is gone.
5. Damage caused by operating the speakers at distorted
volume levels is not covered by the warranty.
SAFETY INSTRUCTIONS
1. When the speakers are installed in the wall, ensure the
wall structure is reliable and that the speakers are rmly
attached.
2. Install the speaker in a location that can structurally
support the weight of the speaker and its mounting
hardware. Otherwise it may result in the unit falling down
and causing personal injury.
3. Do not use nails, adhesives or other unauthorized devices.
Long-term use and vibrations may cause it to fall easily.
4. Do not touch or bump the woofer and tweeter. If these
are damaged, the sound will be distorted.
5. Lower the sound volume when you are changing the
input source (for example, to tune FM/CD). Make sure
that the power amp/amplier device radio is turned o
when installing or removing the cables.
Users Have a Responsibility to Place or Install Safety
The speakers that are placed in the holder can be either
wall or ceiling type, using screws to be placed inside of
the speakers in the back is optional.
1. Mark the mounting bracket as a template with the
regional location of the hole slots.
2. Then use the appropriate hardware and tools (not-
supplied) to properly x it to the bracket wall/ceiling.
3. Place the speakers to the bracket using the screws and
washers according to the speaker.
PACKING LIST
Speaker Power Cable User Manual
1. Aux Input
2. RCA Input
3. Balance Input
4. Loop Output
5. Sub Output
6. Speaker Output
7. LED Indicator
8. Treble Adjustment
9. Bass Adjustment
10. Volume Control
11. Power Switch
12. AC Power Cord
