Pyramid Gold Series User manual

PYRANNO
Gold
зегісу
REGULATED DC
POWER SUPPLY
MODEL: Р5-26КХ
INSTRUCTION MANUAL
GENERAL SPECIFICATION — veve PAGE2.
SCHEMATIC
П!АСКАМ
77”
РАСЕЗ.
OPERATION MANUAL & CAUTION: PAGE 4.

GENERAL SPECIFICATIONS:
MODEL NO:PS-26KX
ELECTRICAL:
(A - МРОТ RATING.
INPUT VOLTAGE: IO5VAC - 125МАС. (1 I5VAC NORMAL).
INPUT LINE FREQUENCY: 60 Hz.
INPUT POWER: БООМ МАХ.
(A—2) OUTPUT RATING.
OUTPUT VOLTAGE: 6.0VDC — 1 5VDC.
OUTPUT POWER: ЗООМ МАХ/ 1З.ВУОС АТ 22АМР МАХ.
OUTPUT RIPPLE: 15Оту RMS
(A-3) REGULATION.
LOAD REGULATION: 2% MAX.
LINE REGULATION: 1% МАХ. (1 О5УАС- I 25VAC)
(А- 4) PROTECTION.
INPUT LINE PRECAUTION: GLASS TUBE FUSE бА/25ОМУАС (МОМ-ТІМЕ DELAY).
OVER-LOAD PRECAUTION: 90%RATED LOAD PRECAUTION DEVICES. # SEE
OPERATION#
OVER-LOAD PROTECTION: 22АМР + 2АМР. (INSTANT AUTOMATIC RESET).
OVER-VOLTAGE PROTECTION: I6VDC +0.5V. (AUTOMATICALLY SHUT OFF).
OVER-TEMPERATURE PROTECTION. (AUTOMATIC RESET) # SEE ОРЕВАТІОМ»
COOLING FAN BUILT-IN.
(А- 5) EFFICIENCY: 60% MIN. (INPUT АТ |I5VAC AND OUTPUT АТ 1З.ВУрС 22АМР).
(A-6) DESIGN: LINEAR ТУРЕ.
(А- 7) OPERATING TEMPERATURE: O TO +40 DEG C.
(А 8) STORAGE TEMPERATURE: 25 ТО +70 DEG С.
MECHANICAL:
(B— 1) DIMENSIONS: 300mmx230mmx I 8Отт. (LxWxH)
(в-2) WEIGHT: 8 KGS
(В-3) ENCLOSURE: BLACK
(В—4) INPUT POWER CABLE: SVT/I8AWGx3C/6FT MIN. WITH NEMA 5-15Р PLUG
(В-5) OUTPUT TERMINAL: BINDING POST, RED & BLK, 25АМР.
(В-6) VOLTAGE & AMPERE METER: ANALOG ТҮРЕ, CLASS 2.5%.
(В- 7) POWER SWITCH: ILLUMINATED TYPE, 15А/125\/АС.
(В-8) POTENTIOMETER: OUTPUT VOLTAGE ADJUSTABLE.
(8-9) L. Е. D. ІМОІСАТОВ: BLINKING TYPE/RED FOR PRECAUTION DEVICES.
га

AGZ/ АПОО ,
_лбг/ —
5655417 — Нос
ЕС.
jE?
^91/ 310001
Бот 65 [ХУ CXA YOC ЕЯ
+ | [2271 -{ |
$11 УЧ XG CYA
иш ор
936 CY
Ок 63 rot У5
өлү іа _
єбБєєсм 1а
«
СО0УМЬ $0
z
INPUT
115V 60Hz
азч аз
2% Хі 13
2
1
Х/ӯ 94 3001 ZJ
А62/3"001
9Х-
Жж» LH
ZOON! са
Р5-26КХ BASIC CIRCUIT DIAGRAM

нь
. INSERT AC POWER PLUG INTO А I| IOV VOLT АС OUTLET
2:
CONNECT THE POWER CORD ОҒ YOUR EQUIPMENT (6.0\-15.0У0С) ТО THE OUT-
PUT BINDING POST TERMINALS ON THE FRONT OF THE UNIT. BE SURE THAT PO-
LARITY IS CORRECT. THE RED POSITIVE(+) TERMINAL AND BLACK МЕСАТІУЕ(-
TERMINAL ARE MARKED; REVERSAL OF POLARITY MAY DAMAGE BE YOUR EQUI-
PMENT.
TURN SWITCH TO “ON”. RED LIGHT IN SWITCH WILL ILLUMINATED.
: TURN THE VOLTAGE ADJUST TO THE VOLTAGE LEVEL REQUIRED IN THE ОС УО--
LTAGE METER. THE CORRECT VOLTAGE IS THE ACTUAL VOLTAGE REQUIRED BY-
YOUR EQUIPMENT. DO NOT TOUCH THIS VOLTAGE ADJUST IN OPERATION WHEN
VOLTAGE HAS BEEN SET UNLESS YOU WANT TO CHANGE OUTPUT VOLTAGE.
THE INPUT POWER IS PROTECTED BY THE FUSE WHICH IS LOCATED AT THE RE-
AR OF THE UNIT AND CAN BE REPLACED BY UNSCREWING THE FUSE HOLDER IF
THE FUSE IS BURNT OUT. DO NOT USE A FUSE LARGER THAN 6 AMP. USE OF
HEAVIER FUSE MAY RESULT IN DAMAGING TO THIS UNIT.
. THIS UNIT HAS PRECAUTION DEVICES. THE PRECAUTION DEVICES WILL OPERA-
TE. BUZZER WILL BUZZ AND L. E. D. INDICATOR WILL BLINK. WHEN THE OUTPUT
CURRENT REACHES 90% OF THE RATED CURRENT. IF YOU RETAIN THIS CONDITI
ON FOR MORE THAN 30 MINUTES. THE OVER-TEMPERATURE PROTECTION MAY
BE AUTOMATICALLY TRIP AND IN TURN OFF THE OUTPUT VOLTAGE.
. THIS UNIT HAS ELECTRONIC OVERLOAD PROTECTION WITH INSTANT AUTOMATIC .
RESET FUNCTION. IF OUTPUT IS OVERLOADED. THE OUTPUT POWER WILL AUTO
MATICALLY SHUT СЕР. RELEASE POWER CORD OF YOUR EQUIPMENT FROM THE
OUTPUT TERMINALS AND CHECK THE ACTUAL POWER RATING OF YOUR EQUIP-
MENT. THIS UNIT WILL AUTOMATICALLY RESET INSTANTLY.
‚ THIS UNIT HAS OVER-VOLTAGE PROTECTION. WHEN THE OUTPUT VOLTAGE OV-
ER І6У,ТНІ5 POWER SUPPLY WILL AUTOMATICALLY SHUT OFF.
. THIS UNIT WiLL AUTOMATICALLY SHUT OFF WHEN THE TEMPERATURE INSIDE
THIS UNIT REACHES 105%. ІТ WILL МОТ RETURN TO THE NORMAL STATUS UNTIL
THE TEMPERATURE INSIDE THIS UNIT IS DOWN ТО 70%.
CAUTIONS:
|.
2.
З.
4.
ОО МОТ USE WITH EQUIPMENT REQUIRING MORE THAN 22 АМР.
DO NOT USE OUTDOORS. DO NOT EXPOSE UNIT TO RAIN, MOISTURE, WATER OR
ANY OTHER LIQUIDS.
DO NOT REMOVE COVER IN ANY CASE. RETURN TO DEALER FOR REPAIR IF DAM-
AGED.
THIS UNIT HAS A'SPECIAL BUILT-IN FEATURE THAT WILL SHUT THE UNIT DOWN
IF MARKED AMPERAGE IS EXCEEDED. THIS WILL AVOID BURN-OUT OF YOUR EQ-
UIPMENT AND OF UNIT. IF UNIT DOES CONSISTENTLY SHUTDOWN, THIS MEANS
YOU ARE DRAWING TOO MUCH AMPERAGE. RETURN UNIT TO PLACE OF PURCH-
ASE AND UPGRADE TO NEXT AVAILABLE UNIT OFFERING HIGHER AMPERAGE. Р-
LEASE
DO
NOT
BYPASS
OR
ALTER
THIS
CIRCUIT
AS
IT
IS
THERE
TO
PROTECT
Y-
OU.
ANY
ALTERATION
OR
MISUSE
WILL
VOID
YOUR
WARRANTY.
"ОАМСЕВ"
HIGH VOLTAGE
REFER TO QUALIFIED TECHNICIAN FOR SERVICE.