
Step 1 Test components before installation Connect the controller to the switch, connect the
7’’ halo rings to the controller, and then connect the switch harness to the 12V power supply.
Press
the controller switch button open the app pair the bluetooth test the halo rings.
Step 2 Controller installation Place the controller around the main driver's seat is suggested. Connect the
driving, braking, and steering wires on the controller to the corresponding automobile wiring harness assembly. Pass the
switch wires through the engine compartment then connect with the positive and negative of battery. (Note: This step
should be performed by relevant professionals).
Step 3 Extensive wire installation Take one 100’’and one 145’’ extension wires to connect to the 2 ports of
the controller. The 100’’ extension wire pass through the left side of the engine compartment to connect zone 1 and 145’’
extension wire from the right to connect zone 2 .
Step 4 Install the halo ring Remove the headlights > embed the halo rings to the headlights and make sure
they fit in perfectly> connect the halo rings with the extension wires > install the headlight to orignal place.
MOUNTING STEPS
First, please make sure your phone has downloaded and installed the Higlow APP.
zone
4
zone
3
zone
2
zone
1
Higlow Series - 7‘’ Halo Ring Kit
02
zone
4
zone
3
zone
2
zone
1
WHITE - Brake
YELLOW - Right
BLACK - Left
RED - Positive
BLACK - Negative
Controller Switch
7‘’ Halo Ring