CONNECT THE IQ WiFi 6 CONTROLLER
POWER UP THE IQ WiFi 6 CONTROLLER
This is a quick guide for experienced installers only. Refer to https://qolsys.com
CONNECT TO THE MODEM OR EXISTING NETWORK
Plug the power supply into the wall
outlet. Router takes about 6
minutes to power up and identify as
a controller, the power LED will stop
flashing when ready.
Note: If a software update is needed
the router will automatically
download and install it. This may take
an additional 2 minutes.
While waiting for Agents to pair, unbox
any agents and power them up.
ADD ADDITIONAL AGENTS (IF NEEDED)
Add one or more Agents if needed. Agents expand the area
covered by the network. Once added, Agents use the same
SSID and PW as the controller.
1. Power up the Agent (see step 3). Ready when Controller
and Agent LEDs are solid GREEN.
2. Press the WPS button on the Controller
3. Press the WPS button on the Agent
Note: LET PROCESS FINISH, COULD TAKE UP TO 7 MINUTES to
finish pairing, updating, and configuring each Agent. You can begin
pairing subsequent Agents when the Controller WAN LED goes solid
GREEN. Paired Agents default to WiFi backhaul but support
ethernet backhaul with an ethernet connected LAN-to-LAN.
2. Connect the provided ethernet
cable into the “WAN” port.
3. Plug the barrel jack end of the
power supply into the “DC-IN”
port. Do not plug in the power
supply into outlet until step 3.
1. Connect one end of the provided ethernet
cable into the “ETHERNET” port on the
modem*.
*Note: for parallel installs plug the
ethernet cable into an available port
on the customer’s existing router (see
additional considerations)
NOTE: The Controller is the only node with a WAN port connection.
