
1
2
1. Insert the OPS into the special slot on the rear of the
interactive panel.
2. Tighten the screws.
3. Confirm that the OPS is installed correctly.
Note: The OPS does not support hot-plugging. Please
insert the plug of the OPS after the interactive panel is
disconnected from the power.
OPS
Installation
Item Icon Function Description
1 Brightness sensor: Auto adjust brightness according to the environment
2 Remote control receiving, effective receiving area ≈3m≤ 30° , or≤ 5m vertical.
3
Android/PC USB port*2 auto switch (Do not switch the signal source if the usb
flash drive is writing.)
Touch Port, designated for Front HDMI port
HDMI port used to connect an external display device
4 Front Speakers
5 Magnetic pen holder
6
Enter/Return to Android home page
Return to previous interface
Decrease volume
Increase volume
Enter ECO mode to turn off the display
Enter/Exit Setting menu
Enter/Exit signal source menu
Power button: On or standby mode
2 3
1 4 5 6
JOURNEY 14 PANEL
QUICK START GUIDE
(If you do not have an OPS, you may skip the following step)
Install the OPS by the following steps: