QTP 10900 User manual

ANTENNA
(+) 12v Power Source
(-) 12v Ground
TECHNICAL SUPPORT
[phone]
Monday through Friday
9AM-4PM EST
email
[e-mail]
Operation Instructions
1. To open the cutouts, hold the "OPEN"button
until the desired exhaust sound is achieved. It
will take approx. 5-6 seconds to open the valve
to the full open position.
2. To close the cutouts, hold the "CLOSE"button
until the desired exhaust sound is achieved.
TIP: For best results, lubricate the cutout valve
butterflies at least once a month to keep them
free of debris and carbon build up.
intermediate wire
wireless receiver box
12v Power Input
12v Ground Input
Antenna Wire
LEGEND
PART # 10900
Wireless QTEC Controller
Thank you for your purchase of the Wireless QTEC Controller. This controller will support both single
and dual Quick Time Electric Cutout applications. Your kit comes with the wireless receiver and 2 key
fob style remote controllers.
Install Instructions:
1. Find a suitable,secure, dry location for installation of the wireless control box. Receiver must be mounted
inside the vehicle and wired to a fused ignition power source or warranty will be voided. Remember you will
need to supply both a 12volt ignition power source as well as a ground.
BE SURE to run the Positive (Red/+) wire to your vehicle's 12v hot source and the Ground (Black/-) wire to a
suitable ground on the chassis. Please note: Hooking these wires up backwards will damage the
receiver!
2. After securing the receiver and connecting power and ground, hook up your intermediate wires between
the valves and receiver box. Be sure to route the intermediate wires so they don’t come into contact with your
exhaust system or any other area of the vehicle that could cause scraping & chaffing.
You're Done!
OPEN CLOSE

Notice of Disclaimer and Liability
The Federal Government, each of the fifty states, local municipalities, towns and counties all regulate emissions production, noise levels, and
safety standards. Quick Time Performance makes no warranties of merchantability, of fitness for a particular purpose, or that its products are
approved for general use, or that its products comply with laws, regulations or ordinances in the states where they may be sold to the ultimate
purchaser, the consumer. Unless stated otherwise on our website, instruction sheet, or price list, all risk to the conformity of any of the products
offered by Quick Time Performance or its affiliates in any such state and as to repair should the product prove defective or non-conforming, is on
the retail purchaser, the buyer, the ultimate consumer of such product and it is not upon the seller, distributor or manufacturer. In this
connection, the retail purchaser, the buyer, the ultimate consumer assumes the burden of the entire cost of any and all necessary service,
alterations or repair. The foregoing statement LIMITS THE LIABILIT Y OF QUICK TIME PERFORMANCE AND ITS AFFILIATES. QUICK
TIME
PERFORMANCE AND ITS AFFILIATES ASKS THAT YOU REMEMBER THAT RACING VEHICLES NEVER BE DRIVEN ON A HIGHWAY
OR STREETS ANYWHERE IN THE UNITED STATES. It is illegal to remove or render inoperative any emission control device on any vehicle.
Our products are intended for racing vehicles, which have never been intended to be driven on any highway or any street in the United States. In
California Vehicle code sections 27156 and 38391 prohibit the advertising, offering for sale, or installation of any device, which modifies a vehicles
emission control system unless exempted. Quick Time Performance and its affiliates have not received an exemption from these code sections and
are not legal for sale or use in California on vehicles originally equipped with a catalytic converter. Our products are for racing vehicles, which are
never intended for
highway or street use. Our products are subject to price change without notice. We reserve the right to reject and cancel any order.
Warranty
Quick Time Performance Inc. provides a limited warranty against defects in materials and workmanship for a period of 90 days from date of sale
to the original purchaser. Upon inspection and verification of warranty, Quick Time Performance will, at its option, repair or replace products,
which prove to be defective.
Exclusions & Limitations
• Any product , which has been subjected to abuse, accident , alteration, neglected maintenance or improper installation, renders the product
warranty null and void.
• Conditions resulting from acts of nature, weather, criminal activity or accidents are subject to adjustment under the product warranty.
• Shipping and handling charges are the responsibility of the end user and are not covered by warranty.
• Any and all labor charges that may be incurred for the removal and or replacement of any covered component or the purpose of affecting this
warranty are the sole responsibility of the consumer.
• Leakage
Return Policy
Quick Time Performance will not accept shipments without prior authorization. In the event it is necessary to return an unused product within
30 days, a return of goods authorization must be obtained from Quick Time Performance a letter of explanation should be included in the
package as well as an invoice or receipt.
Questions?
Quick Time Performance Technical Team is available Monday through Friday (9AM-4PM ET) at [phone] or via email at:
[email protected]