www.avsl.com 154.030UK User Manual
Colour jump setting (speed slow to fast)
Colour fade setting (speed slow to fast)
Colour pulse setting (speed slow to fast)
Strobe setting (speed slow to fast)
Sound to light white strobe setting
Sound to light colour change setting
Remote control:
The PAR100 is supplied with an I.R. remote control for quick access to most of the basic functions of the
unit. This must be aimed at the front of the unit where there is a remote receiver and has a maximum
range of approximately 4-5m. Controls and functions are listed on the diagram below:
DMX mode:
The PAR100 can be controlled by DMX signal, simply connect the DMX signal source to the DMX input on
the unit via a balanced XLR lead. Extra fixtures can be controlled by the same DMX signal by looping
through the DMX out on the unit. To enter DMX mode, select A001 from the menu and confirm the correct
start address by using the “UP”and “DOWN”buttons and “ENTER”to confirm.
This unit has 7 DMX channels as indicated in the table below:
Strobe (speed slow to fast)
1. Power = Remote on/off
2. Auto = Colour jump open/off
3. Mode = Colour fade open/off
4. Flash = Strobe open/off
5. -- = Decrease option setting
6. R = Red open/off
7. G = Green open/off
8. Enter = Save option setting
9. Music = Sound to light colour
change open/off
10. Motor = Manual colour select
11. + = Increase option setting
12. Dmx = DMX512 open/off
13. B = Blue open/off
14. W = No function on this model
(achieve white by opening red,
green and blue concurrently)
