Qubo MICRO MINI MEDIUM MAXI HP User manual

ASSEMBLY AND OPERATING INSTRUCTIONS:
Made in Italy
-COD. 101601
-COD. 101605
-COD. 101606
-COD. 101607
QUBO MCRO HP
-Power consumption : 6W
-Voltage : 220-240V 50-60Hz
-olor Temperature : 3000K - 4000K
-Beam angle : 4°-10-28°
-Insulation class: III
-IK rating : IK10
-IP protection: IP66
-Gross weight: 0.7kg
COD. 101601
-Replace the damaged protective glass
-Getting rid of as urban waste forbidden
-Separate collection is mandatory when the product is at the
end of its life
-lass I fitting electric grounding is needed
-OD 101605
-OD 101606
-OD 101607
IP66
NB: These assembly instr ctions m st be given to end sers for correct maintenance and so that they know how to change the b lb.
The appliance m st not be tampered with or transformed and it m st be installed and sed as s pplied and in compliance with the
National R les on Installations. Any non-compliant installations will invalidate all forms of g arantee. The company cannot be held
The article is suitable for indoor and
outdoor use
Retain the instructions
-Electronic equipment sensitive to voltage surges.
The installation of a protective device against
overvoltages on the electrical system attenuates
the
phenomena protecting apparatus from the risk of
damage.
Do not use high pressure cleaners
IK10
QUBO MINI HP
-Power consumption : 8W
-Voltage : 220-240V 50-60Hz
-olor Temperature : 3000K - 4000K
-Beam angle : 4°-10°-28°
-Insulation class: I
-IK rating : IK10
-IP protection: IP66
-Gross weight: 1.3kg
COD. 101605
protection class III
products that can only be operated with protec-
ted extra-low voltage
-OD 101601

Recommendations
1) verify that the equipment used to connect our devices to enjoy
all the guarantees required under European law;
2) use the cables, connectors and quality materials for electrical wiring;
3) Products with IP66 degree make the wiring / connections with accessories
provide the same degree IP of the selected product (available in the catalog);
4) In the case of installations outside is not recommended to install the power supplies in the
formwork and / or in the junction box without adequate protection
5) Honey-comb louvre must be installed directly from the manufacturer . Please mention it during the order
Choice of installation location
The unit should be positioned so that when in use is not subject to direct radiation from the sun or other heat sources . High temperatures
reduce the life and efficiency of the components or the LED module .
Note on corrosion protection
For installation and maintenance be especially careful not to damage the coating powder . Damage combined action of water could cause
corrosion.
-In the case of damage to the external flexible cable, it must be replaced by the manufacturer, or its assistance service, or equivalent quali-
fied personnel in order to avoid dangers
Use only s pply cables with
do ble case Do not se water high
press re cleaners
QUBO MEDIUM HP
-Power consumption : 20W
-Voltage : 220-240V 50-60Hz
-olor Temperature : 3000K - 4000K
-Beam angle : 4°-10°-28°
-Insulation class: I
-IK rating : IK10
-IP protection: IP66
-Gross weight: 3.1kg
COD. 101606
QUBO MAXI HP
-Power consumption : 38W
-Voltage : 220-240V 50-60Hz
-olor Temperature : 3000K - 4000K
-Beam angle : 4°-10°-28°
-Insulation class: I
-IK rating : IK10
-IP protection: IP66
-Gross weight: 4.5kg
COD. 101607

Installation:
1. Loose the two bracket screws (using the tool included in the package) and remove the fixing bracket pic.1
2. Prepare holes in corrispondance of the feeding point pic. 2
3. Fix the bracket to the floor tighten the screws of fischer plugs (not included in the package) pic. 3
4. Prepare the cable through the feeding point hole pic4
5. Make the adeguate electrical connection
6. Fix the luminaire to the bracket tighten the two hexagonal screws pic. 5
7. Make the regulation of the luminaire then fix it by tighten the grub screw (using the tool included in the package) pic 7
A ESSORIES

  



QUBO MINI QUBO MEDIUM MAXI
QUBO MICRO

See the connector accesso-
ry instruction
nformation for users
stream. To prevent possible harm
to the environment or human health please separate this product from other waste streams to ensure that it can be
where you purchased this product.
I informazioni agli utenti
del prodotto.
D Richtlinie 2002/96/EU (Elektro- und Elektronik- Altgeräte - WEEE):
Benutzerinformationen
Zur Vermeidung einer mögli-
chen Beeinträchtigung der Umwelt oder der menschlichen Gesundheit darf dieses Produkt nicht in den Hausmüll gegeben
die zuständige Behörde oder das Geschäft, in dem Sie dieses Produkt erworben
haben.
F Directive 2002/96/ E (Déchets d’èquipements èlectriques et èlectroniques - DEEE):
informations aux utilisateurs
l’administration locale ou le détaillant auprés duquel vous avez acheté ce produit.
E Directiva 2002/96/ E (Residuos de aparatos eléctricos y electrónicos - RAEE):
Información para el usuario
donde adquirió este producto
SE Directive 2002/96/ E (Waste Electrical and Electronic Equipment - WEEE) information for users
en lokal myndighet elleder den återförsäljare som du köpte produkten från.
NL Richtlijn 2002/96/EG (Afgedankte Elektrische en Elektronische Apparaten - AEEA):
informatie voor de gebruikers
gemeente of de leverancier bij wie u dit product hebt gekocht.
AND OF THE OUN IL OF 27 January 2003 on waste electrical and electronic equipment (WEEE) and legislation trasposing and imple
- menting it into the various national legal systems.