Quectel GT300 User manual

GT300 Quick Start
For SW Version B01
Page 1 : Basic Operation
Find “GT300 Manager Tool Ver2.00.exe”
in develop suit and run it to configure
the running parameters of GT300.
Please refer to Page 2 for detail.
Better place the GT300
under the open sky, and let
the top side to the sky.
Turn On GT300
Find “PL2303_Prolific_DriverInstaller_v10518.zip”
in develop suit and install the drive for PL2303. If
you have already installed it please go to Step 6.
Check The Appearance
Check Parts List
Install SIM Card
To mini USB
To computer
Here is GPS Antenna
The USB Data_Cable_M is
not in the delivery list.
Please contact your vendor
for it.
Power Key
Connect GT300 to computer by USB
Data_Cable_M.
Before the first time using GT300,
please full charge the battery

Page 2 : PC Manager Tool Quick Start
After these steps. GT300 will have some
basic tracking functions like scheduled
timing report and Geo-Fence. For other
advanced functions of GT300 please
refer to “GT300 @Track Air Interface
Protocol” or visit our website
Quectel Wireless Solutions
Website : www.quectel.com
Email : [email protected]
Run manager tool. Select correct Com port and
input default password “gt300”. Then press OK.
If you want to test the GT300 by SMS then set “Report
Mode” to “Force on SMS” and input the phone
number which you want to receive the SMS from
GT300. After that you can go to Step 6.
Otherwise please go to Step 3
Set “Report Mode” to “TCP Short Connection”. input
the IP address and port number of the backend
server. Please make sure the IP address can be
accessed by internet and the data sends to this
address can be received.
Please contact your SIM card provider and get the
APN information for GPRS. Input it to the “GPRS
Setting”
Press the “Send” button and update the
parameters of GT300. Then the GT300 can
report information to your backend server or
SMS receiver.
Note: This command can also be sent to
Command has been accepted when you see the
success window.
Set the parameters of scheduled fixed timing
report so that the GT300 will report it’s position
to backend server periodically. Press “Send”
button to update the parameters.
Follow screen shot shows how to configure the
GT300 to report it’s position every 2 minutes.
The following screen shot shows how to create a
Geo-Fence rule. Press “Send” button to update the
parameters.