Questtel L-1000IP-TRX User manual

User Manual
10/100/1000M Dual Fiber Media Converter
L-1000IP-TRX

QuestTel 10/100/1000M Ethernet media converter adopts switching technology
to fulfill media conversion. It complies with IEEE802.3z and IEEE802.3ab
standards, and supports two types of media network connections:
10/100/1000Base-T and 1000Base-SX/LX. It inter-converts electrical signals of
10/100/1000Base-T twisted pairs with optical signals of 1000Base-SX. It extends
the network transmission distance from 100m to 80km(declare before order)
via fiber optical cable. It supports transmission in multi-mode dual fiber; single-
mode dual fiber.
Description
Features
-Supporting inter-conversion between 10/100/1000Base-TX and 1000Base-SX
-Supporting full-duplex and half-duplex and its auto-sensed
-Supporting automatic cross connection of twisted pair interfaces, facilitating system
commissioning and installation
-Supporting the transmission of extra-long VLAN packets
-Supporting Quality of Service (QoS) and ensuring the transmission of VoIP packets;
-Supporting STP to form a redundant network
10/100/1000M Dual Fiber Media Converter
L-1000IP-TRX
www.questtel.com [email protected]

Technical Datasheet
Parameter Specifications
Standard Protocol
IEEE802.3ab 1000Base-T
IEEE802.3z 1000Base-SX/LX Gigabit ethernet
IEEE802.1qVLAN,IEEE802.1p QoS
IEEE802.1d Spanning Tree
Band Width
RJ 45 Port: 10/100/1000Mbps
Optical Port: 1.25G
Switching
Support Store & Forward
Operation Mode
Full /Half duplex mode
Connectors
UTP:RJ-45
Fiber connector: SC/UPC
Operation Mode
Full /Half duplex mode
LED Indicators
POWER, FPL,10/100/1000, FRX, TRX , FDX.
Power Supply
Internal
AC100-240V/50~60Hz
DC 5V 1.2A
Output Voltage
uncertainty ±3% (without load)
Output Voltage:
Continuous current ≥ 90%
nominal current; ±5% nominal DC
Voltage; Vpp ≤ 150mV
Voltagesurge protection
Intergrates the voltage surge protection
(arrester)equipment.
Environmental Parameters
Work Temperature
-5℃~+55℃
Storage Temperature
-40℃~70℃
Humidity
5%~90% non-condensing
TP Cable
Cat5 UTP cable (the max distance up to 100m)
Fiber Cable
Single Mode
Size
94mm*70mm*25mm(L*W*H) (External power supply)
TECHINCAL SPECIFICATIONS
10/100/1000M Dual Fiber Media Converter
L-1000IP-TRX
www.questtel.com [email protected]

Application Drawing
LED indicator lamp Status Explanation
FX Link/Act
On Connection status display for fiber link.
“ON” indicates that Fiber link is in correct connection.
Blink Active status display of fiber link
“Blink” indicates packet goes through Fx end.
TP Link/Act
On Connection status display for electric link.
“ON” indicates that electric link is in correct connection.
Blink Active status display of electric link
“Blink” indicates packet goes through Tx end.
DUP On Transceiver works in the full duplex mode.
Off Transceiver works in the half duplex mode.
PWR On Power is on and normal.
SD On Fiber signal is detected.
1000 On Transfer rate of electric interface is 1000Mbps.
Off Rate of electric interface is 1000Mbps
LED INDICATORS
10/100/1000M Dual Fiber Media Converter
L-1000IP-TRX
www.questtel.com [email protected]
WARNING !
This unit outputs continuous invisible light, which may
beharmful to the eyes; use with caution. For additional
safety, plug the attached dust caps into the optical
transceivers when the fiber optic cable is unplugged.
Direct viewing into optical connectors should be avoided
at all times!