Quirky Bubba Sienna Cot User manual

PART 1
PART 4
PART 3
PART 2

PART 6
PART 5
14 X SCREWS
1 X L KEY

Start by attaching parts 1 and 3
together using 2x screws, secure
the parts together by inserting the
screws through the holes in part 1
and into part 3.
PART 1
PART 3
Make sure to line up the letter
A on part 1 to the letter A on
part 3.
PART 3
PART 2
Repeat Step 1 on the other side
of the Cot, securing Part 2 to
Part 3. Screw 2 x screws (using
the L key) through Part 2 into
the screw holes provided in
Part 3.
Make sure to line up the letter
B on part 2 to the letter B on
part 3.

PART 1
Attach part 1 to part 4
using 2x screws, screwing
them through part 1 into
the screw holes provided
in part 4.
PART 2
Repeat Step 3 on the other side of
the Cot, securing Part 2 to Part 4.
Screw 2 x screws (using the L key)
through Part 2 into the screw holes
provided in Part 4.
PART 4
Make sure to line up the letter
D on part 1 to the letter D on
part 4.
PART 4
Make sure to line up the letter
C on part 2 to the letter C on
part 4.

Place the cot on its side like in
the photo.
Then insert part 6 in at the
bottom of cot and secure to
parts 1 and 2 using 4x screws
through the holes provided.
PART 6
PART 5
Insert Part 5 into
the Cot, resting on
the mattress base
holders in each
corner of the cot.
Finally screw in part 3 and 4
into part 6 using 2x screws
through the screw hole at
the bottom of the cot on
either sides.

Remove Part 4 by
unscrewing 5 x
screws from Parts 1,
2 and 6.
The cot may come with the mattress base
holders attached, they are on the lowest
setting and they are removable.
To put them on the highest setting unscrew
the screws and move them up to the new
born setting.

Insert Part 5 into
the Cot, resting on
the lowest mattress
base holders in each
corner of the Cot for
the toddler bed
setting.
PART 5