SAFETY INSTRUCTIONS
7. Do not use the product near a heat source, such as a fire source or a
heating furnace.
8. Avoid contact with any liquid. Do not immerse the product in water
or get it wet. Do not use the product in rain or humid environments.
9. Do not use the product in an environment with strong static
electricity or magnetic fields.
10. Do not disassemble the product in any way or pierce the product
with sharp objects.
11. Avoid using wires or other metal objects that may result in a short
circuit.
12. Do not use unofficial components or accessories. If you need to
replace any components or accessories, please visit official R3Di
channels to check relevant information.
13. When using the product, please strictly follow the operating
environment temperature specified in this user manual. If the
temperature is too high, it may result in a fire or explosion; if the
temperature is too low, the product performance may be severely
reduced, or the product may cease to work.
14. Do not stack any objects on the product.
15. Please avoid impact, falls, or severe vibrations when using the
product. In case of a severe external impact, turn off the power supply
immediately and stop using the product.
16. If you accidentally drop the product into water during use, please
place it in a safe open area, and stay away from it until it is completely
dry. The dried product should not be used again and should be
properly disposed of.
17. Use a dry cloth to clean off dirt on the product ports.
18. Rest the product on a flat surface to avoid damages caused by the
product falling over.
PRIVACY
Please note that you must respect the laws and regulations in your jurisdiction or
other jurisdiction(s) where you will use your phone regarding taking photographs
and recording sounds with your phone. Pursuant to such laws and regulations, it
may be strictly forbidden to take photographs and/ or to record the voices of other
people or any of their personal attributes, and reproduce or distribute them, as this
may be considered to be an invasion of privacy. It is the user’s sole responsibility to
ensure that prior authorization has been obtained, if necessary, in order to record
manufacturer, the seller or vendor of your phone (including the carrier) disclaim
any liability which may result from improper use of the phone.
DISCLAIMER
Certain variations may be present between the device and user manual
description depending on software release or specific network services.
ATEL shall not be held legally responsible for such deviations, if any, nor
for their potential consequences.
LIMITED WARRANTY
The full ATEL USA Warranty Policy can be found at www.R3Di.com/
warranty. On this page you can “Start a Warranty Claim”, “Check on
an Existing Claim” and read the Warranty Policy by clicking on “ATEL’s
Warranty Policy”. Please follow all warranty instructions available and
if you have any questions contact us at support@R3Di.com . Note that
some actions such as, but not limited to, using sharp objects to open
the device, may void the warranty.
For any questions related to your FR150, you can contact ATEL Support
at support@R3Di.com or 1-866-4-GETR3D (866-443-8733).
TRADEMARK
ATEL & R3Di are trademarks owned and protected by Asiatelco
Technologies, Inc.
© 2023 Asiatelco Technologies, Inc. All right reserved.
For additional information, visit support@R3Di.com or visit www.R3Di.
com.
5.
