Raceseng TUGLESS VIEW User manual

TUGLESS VIEW
INSTALLATION GUIDE

PARTS LIST
•Knob
•Mount
•Nut
•Shaft
•Knob Bolt
TOOL LIST
•Small Screw Driver
•Masking Tape
•Drill
•1/2” Drill Bit
•Grease
•20mm Socket
•Ratchet Wrench
•25mm Wrench or Tug Tool
•5/8” Wrench
Mount Nut ShaftKnob
Knob Bolt

NEED TECH HELP?
[e-mail]
INSTALLATION GUIDE
** IF YOU HAVE A RACESENG TOW HOOK, PROCEED TO STEP 4 **
1 Use a small screw driver to remove the tow hook bumper cover. To avoid damaging your bumper paint, put a strip
of masking tape on the bumper underneath the pry slot of the cover.
2 Clean the tow hook shaft threads in the bumper beam. A blast of air or wire brush will suce. The key is to
remove any debris from the threads.
3 Apply grease to the threads of the Shaft that screws into the bumper beam. Insert and thread the Shaft into the
bumper beam.
4 There is a hex machined on the front of the Shaft. Use 20mm socket and ratchet wrench on the hex to tighten
the shaft into the bumper beam.
5 Apply grease to the threads of the Mount. Then, thread the Nut onto the Mount until it bottoms out.
6 Level the Mount and tighten the Nut into the Shaft using a 25mm wrench or Tug Tool.
7 Remove the Knob and Knob Bolt.
8 Pass the ears of the GoPro case into the Mount. Put the Knob Bolt through the holes of the mount and thread the
Knob onto the Knob Bolt.
9 Adjust the GoPro’s angle and tighten the Knob with a 5/8” wrench.
10 Enjoy your new Tug View footage!
TRIMMING THE TOW HOOK BUMPER COVER
** OPTIONAL **
1 Remove the Knob and Knob Bolt.
2 Place masking tape over the front and back of the bumper cover.
3 Place the bumper cover over the Mount and mark approxiamately where the centerline of the shaft intersects the
bumper cover.
4 Using a drill and 1/2” drill bit, drill a hole through your marked location.
5 Use a dremel or file to open the hole to the point where the cover passes over the Mount.
6 When the hole is large enough, reinstall the bumper cover, Knob and Knob Bolt.