Rack Pool Tables DRACO T750 User manual

Table Billiard
.Assembly Instructions .Parts List
WARNING:Choking Hazard--Toy contains small balls and/or small parts.
Not for children under 3 years.
IMPORTANT!
Please Keep Your Instructions.Before attempting assembly,please read through this
instruction book to familiarize yourself with all the parts and assembly steps. We
recommend that two adults assemble this game.Please refer to the Parts List
below and be sure that all parts have been included.
PARTS LIST
1
CABINET FOR
BILLIARD
1EA
2
LEFT LEG
2EA
3
RIGHT LEG
2EA
4
END LEG BRACE
2EA
5
SIDE LEG BRACE
2EA

1
6
LEG BOLT
8EA
7
WASHER 8EA
8
LEG BOLT
8EA
9
WASHER 8EA
10
SCREW
8EA
11
LEG LEVELER
4EA
12
CUE STICK
2EA
13
CHALK
2EA
14
TRIANGLE RACK
1EA
15
BILLIARD BALLS
1SET
16
BRUSH
1EA
17
ALLEN WRENCH
1EA
ASSEMBLY INSTRUCTIONS:
We recommend that two adults work together to assemble this game.
Step 1 - Open the carton of your new table game near where you will play.Select a clear level floor.This
game requires at least two adults to assemble the table.
Step 2 - Remove all the contents from inside the carton and verify that you have all listed parts as
shown on the Parts List.NOTE:The player rods are pre-assembled.We suggest that you use the bottom
carton as a clean flat working area to protect the game.Carefully cut or tear the four carton corners so
that the bottom is now your work area.
Step 3 - Attach the Left (#2) and Right (#3) Legs to the support frame using two of the Washers (#7)
and two of Leg Bolts(#6) per leg.Then locate the four Leg Levelers (#11) and screw one into each
Leg.See FIG.2.

2
Step 4 - Attach the two End Leg Braces (#4) to the Legs using two Screw (#10) per Leg.See
FIG.3.
Step 5 - Attach the two Side Leg Braces (#5) to the Legs using two of the Washers (#9) and two of
the Leg Bolts (#8) per Leg.See FIG.3.
Step 6 - At this point two adults should carefully lift the game upright and position it where the game
will be played.
CAUTION:Two adults are recommended to flip the table as shown.
1.Grab the table on the ground.
2.Turn the table over.
3.Place it on all four feet at the same time on the ground.
HOLD
TABLE
CABINET
DO NOT
HOLD THE
LEGS
DO NOT LEAN
THE ON ITS
LEGS !

3
Step 7 - Place a carpenter's level in various positions on the playing surface to determine where
Leveling adjustments may be needed and adjust the leg levelers as needed to ensure that the table
is level.
THE BILLIARD GAME ASSEMBLY IS COMPLETE. YOU
ARE NOW READY TO PLAY BILLIARD.