RACOR PSM-1R User manual

HOME STORAGE PRODUCTS
WWW.RACORSTORAGESOLUTIONS.COM
WARNING
Please read installation instructions carefully prior to installing. Before using the product thoroughly test the fully-weighted
product (with equipment in place) to ensure the product has been installed properly. Do not allow children to play on
product. ITW Brands is not responsible for any damage resulting from improper installation, overloading or product failure.
WHEELBARROW AND
LADDER HANGER | PSM-1R
INSTRUCTIONS
Verify the height of the hook is at a
convenient location and that the
wheelbarrow or ladder has adequate
clearance once hanging.
Position the bracket on the wall with enough
ceiling and floor clearance for the wheelbarrow
or ladder. Make sure the rack is level.
Mark holes through rack mounting plate, drill
1/8” pilot holes and install screws into stud.
Tighten screws firmly.
Phillips driver
1/8” Drill bit
Drill
TOOLS REQUIRED
x2 2’’ (5 cm) wood screws
PARTS LIST
x1 Bracket
1
Clearance
2
MARK

HOME STORAGE PRODUCTS
Thank you for purchasing this product.
Racor storage and organizational
solutions will inspire and put you back
in control of your space. Racor has the
largest variety of solutions to organize
and store bikes, sports equipment,
lawn and garden supplies, bulky items
like ladders and totes, and clutter items
like tools. Please visit
www.RacorStorageSolutions.com for
other great organizational products.
Limited Warranty: These products are sold “as is” without any express or implied
warranties. ITW Brands’ sole liability, if any, shall be to replace this product or refund
the purchase price. The performance of these products is subject to variable
conditions and maximum load ratings are shown for comparison purposes only.
PSM-1R
Made in China
ITW Brands, A division of Illinois Tool Works Inc.
955 National Parkway, Suite 95500
Schaumburg, IL 60173
800-783-7725
www.RacorStorageSolutions.com
Email: [email protected]
© 2011 Illinois Tool Works Inc.
Racor and Racor logo are registered trademarks of Illinois Tool Works Inc.
The bracket can hold a wheelbarrow
or ladder. Simply place the back of the
wheelbarrow or the rung of the ladder
in recess of the bracket.
The wheelbarrow is held in place
against the lip of the bracket by the
arms of the wheelbarrow pushing out
against the wall. A ladder may simply
be held up by one of its rungs.
USING THE BRACKET
AWHEELBARROW PLACEMENT
B
LIP OF WHEELBARROW OR LADDER RUNG