Radware OnDemand Switch 3 XL User manual

How to Install Compression Card
on OnDemand Switch 3 XL
March 2011

TABLE OF CONTENTS
1SCOPE........................................................................................................................................................3
2REQUIRED TOOLS....................................................................................................................................3
3KIT CONTENTS..........................................................................................................................................4
4SAFETY......................................................................................................................................................6
5INSTRUCTIONS .........................................................................................................................................7
5.1 DISASSEMBLY AND OPENING THE DEVICE.............................................................................................7
5.2 INSTALLATION OF COMPRESSION CARD AND ASSEMBLY ......................................................................13
5.3 SAFETY..............................................................................................................................................21
5.4 VERIFICATION &COMPLETION.............................................................................................................21
5.5 TROUBLESHOOTING............................................................................................................................22

1 Scope
This document describes the procedure of installing a compression card in ODS-3 XL model.
2 Required Tools
Tools
Pictures
Notes
Screwdriver model
(size): PH1
Not supplied by
Radware.
Electric Screwdriver,
Type: DRILL &
DRIVER EY 6220
Not supplied by
Radware.
Optional

3 Kit Contents
Tools
Pictures
Notes
Compression Card
including Bracket
Qty.:1
Supplied by
Radware.
Screw
Qty.:2
Supplied by
Radware.

Tools
Pictures
Notes
ESD Protection Kit,
Model: 3M-2209.
Supplied by
Radware.

4 Safety
Before any activities are performed please verify that the device power cable is disconnected. No
maintenance should be performed while device is connected to electric current.
Any person handling the devices should wear ESD protection (wrist strap or ankle strap, etc.).
Table or any other surface that the device is placed upon, should be ESD protected (table top
cover and button).

5 Instructions
5.1 Disassembly and Opening the Device
5.1.1. Place the device on a firm clean surface. It is recommended that the table surface is
covered by padding material (to avoid damage to the device's paint).

5.1.2. Using the screwdriver, remove the 2 screws from the top, holding the device cover in place.

5.1.3. Remove 3 screws form the right side of the device.
Back

Middle
Front

5.1.4. Repeat the same action (removal of 3 screws) on the left side of the device.
5.1.5. After removal of 2 screws from the top and 3 screws from each side (total of 8 screws), slide
the top cover backwards.

5.1.6.
After the cover was pushed back over 10 cm, pull the cover up and remove it from the device.

5.2 Installation of Compression Card and Assembly
5.2.1. Locate the compression card slot.

5.2.2. A close-up from the rear shows that the lower slot is taken by another card. This means that
the compression card will be installed in the top slot.
5.2.3. Remove the card from its package and insert the card into the slot. Verify that the shape of
the connector matches the shape of the socket.

5.2.4. Push the card until the connector is fully inserted into the socket and the bracket connected
to the card touches the vertical bracket connected to the chassis.
5.2.5. Use your finger to gently align the screw holes on both brackets.

5.2.6. Use a screwdriver and one of the screws provided in the kit to connect both brackets and
secure the card in its place.

5.2.7. Place the cover on top of the device.
About 5 cm of the cover should be placed behind the device (so the cover can slide into place).
5.2.8. Slide the cover forward until it is locked in place.

5.2.9. Tighten the two screws on the top cover.

5.2.10. Close the screws on the right side of the device.
Back

Middle
Front