Rak Ceramics RA-ME1314 User manual

MACDONALD INDUSTRIES LIMITED
INSTALLATION INSTRUCTIONS
RA-ME1314
METROPOLITAN DELUXE WALL
HUNG TOILET PAN
PACK INCLUDES
• RA-ME13100P wall hung WC
• RA-ME145400 soft close Urea seat & lid
• Installation Instructions
• Guarantee Form
OPTION
• Inwall mounting bracket - ref RA-WHB

2www.macdonaldindustries.co.nz
NOTES
• Inspect all items thoroughly immediately on receipt to ensure it meets
your requirements.
• Inspect product for defects prior to installation. MacDonald Industries will
not be responsible for any claims related to replacements after a product has
been installed.
• Ensure wall support bracket has been installed to the correct height as required
to meet the contract specification and NZ Building Code G1.
• Check water pressure does not exceed 500kPa. Fit pressure reducing valve
if necessary.
• Check water inlet / waste outlet positions are correct for the WC supplied
according to the measurements in Dia. 1.
• All measurements provided are based on finished wall/floor.
• Installation must only be completed by a registered plumber in accordance with
AS/NZS3500 requirements.
• Correct wall support for any wall hung WC is essential and is totally the
responsibility of the contractor. MacDonald Industries will not accept any claim
for damages caused by inadequate wall structures, materials or incorrect
support for the WC.
Dia 1
337
440
150
340
400
180
135
100
30
65
315
525

MACDONALD INDUSTRIES LIMITED
INSTALLATION INSTRUCTIONS
www.macdonaldindustries.co.nz 3
PRE-LINING INSTALLATION
• Fit wall bracket according to manufacturers instructions ensuring the through
wall fixing bolts are set to a height to allow the pan to meet the height required
for the contract.
• Ensure through wall bolts are at the correct spacing to suit the WC mounting holes.
• Complete installation of inwall cistern or flushing valve to manufacturers
specification allowing the horizontal pipe to extend sufficiently to meet the
pan horn.
POST-LINING INSTALLATION
• Trim horizontal flush pipe as necessary and fit Kee seal.
• If mounting frame is supplied with tile insulation panel, fit to wall.
• Slide WC onto fixing bolts and water/waste pipes, tighten nuts and fit covers.
• Trim around tile insulation panel with sharp craft knife.
• Apply bead of flexible mould resistand silicon around WC.
• Where inwall cistern has been used, flush line thoroughly before final connection
to cistern according to manufacturers instructions.
• Where inwall flush valve has been installed, remove internals of flush valve and
open stop cock to flush debris/air from flushing line for at least 1 minute,
reassemble and test flush.
• Toilet fixing kit - RA-GL08K

Christchurch
P: 03 348 2356
F: 03 348 2376
www.macdonaldindustries.co.nz
10/17
Auckland (Head Office)
20 Carr Rd, Three Kings
Auckland 1042
P: 09 624 1115
F: 09 624 1110
E: [email protected]
Wellington
P: 04 569 8033
F: 04 569 8066