RANCEO See Snake CL15 User manual

CL15 Instruction manual - 1/2
RANCEO
Copenhagen, Denmark
[phone]
See all products on
ranceo.com
Distributor and manufactor:
SCANLICO DENMARK A/S
Marielundvej 46E - 2730 Herlev, Denmark
[phone]
[email protected]
MADE FOR BUILDERS
ATTACH / DETACHED 230 V cable from The See Snake
WARNING!
!
! !
Do not operate flexible light
while it is coiled
15 METER
LED STRIP LIGHT
CONSTRUCTION LIGHTNING
See Snake
Connect the See Snake directly to 230V.
Flexible work light,both for outside and inside use.
1500 Lumens per meter and easy to operate.
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
These products may represent a possible
shock or re hazard if improperly installed or
attached in any way.
Products should be installed in accordance
with these instructions, current and
electrical codes.
To reduce the risk of re, electric shock or
injury to persons, make sure that the
electrical power to the xture is disconnected
at the source prior to installation or any
servicing.
• LED Strip Light only can be bent vertically not horizontally
• Unbalanced voltage drop can cause hazardous overload and damage the flexible light
• Do not route the cord or flexible lighting through walls, doors, windows, or any like part of the building structure
• Do not cover this product as the covering may cause the flexible light to overheat, melt, or ignite.
• Secure this flexible light using only the hangers or clips provided. Do not secure this product or its cord with staples, nails,or like means that may
damage the insulation or permanently attach to the building structure.
• Follow instructions carefully when splicing flexible light sections or attaching power cords. Ensure that all connections, including the end cap on
the last segment,are properly installed with dielectric grease and shrink tube to preclude the entrance of water (outdoor applications)
• DO NOT EXCEED THE MAXIMUM NUMBER OF EXTENSIONS OR FLEXIBLE LIGHT LENGTHS PERMITTED BY THE MARKING.
DO NOT!
!
Do not bend the See Snake to a
diameter less than 25 mm.
Do not fold a sharp corner
on the See Snake.
Do not bend LED Strip Light
on a horizontal plane.
Do not put excessive pressure
on the surface of the strip light
(e.g. glass/acrylic panes etc.).

HOW TO: Extend or repair
Find the blank space Cut Press it inThe cobber wire core Insert pin
Flexible connection, extension and combination solutions!
Light dimmer and Remote - On / Off
Round plug ·
Item no: 9581
Light dimmer and Remote - On / Off
Square plug ·
Item no: 9580
T-EXTENSION
Round plug ·
Item no: 9550
T-EXTENSION
Square plug ·
Item no: 9551
230V CABLE
Square plug ·
Item no: 9501
END CAPS
10 pcs. pr. bag ·
Item no: 9520
I-CONNECTOR
Item no: 9530
T-CONNECTOR
Item no: 9570
L-CONNECTOR
Item no: 9540
I-EXTENSION
Item no: 9560
MOUNTING BRACKETS
50 pcs. pr. bag ·
Item no: 9510
When the strips are assembled and combined with our flexible solutions
I-EXTENSION L-CONNECTOR T-CONNECTOR I-CONNECTION
230V CABLE
Round plug ·
Item no: 9500
CL15 Instruction manual - 2/2
MADE FOR BUILDERS
15 METER
RANCEO
Copenhagen, Denmark
[phone]
See all products on
ranceo.com
Distributor and manufactor:
SCANLICO DENMARK A/S
Marielundvej 46E - 2730 Herlev, Denmark
[phone]
[email protected]