rastar DIY Series User manual

ATTENTIONS
● The guardian of child(ren) should read and understand the contents of this manual before using the
product, and guide child(ren) to use the product properly.
● In order to avoid personal injury, using tools including knives to do assembly should be done by an
adult.
● This product should be stored properly to prevent children from accidentally eating it.
● Properly dispose of the scrap materials when removing the parts, and keep them out of the reach of
children.
● Plastic bags are not toys, which may cause choking hazard. Please dispose of them properly after
disassembly.
● The plastic pieces contain pointed parts. Be careful when assembling and when moving the model
after assembly to avoid personal injury.
● Only alkaline or rechargeable batteries are applicable for the product.
● Different types of batteries or new and old batteries are not to be mixed, exhausted batteries should
be removed from the model.
● The battery should be replaced under adult supervision and be put inside the model with correct polar-
ity. Power terminals must not be short-circuited.
● Non-rechargeable batteries should not be recharged. Rechargeable batteries should be removed
from the model before charging and be recharged under the supervision of adult. Damaged or leaked
batteries are not to be charged.
● Only batteries of the same or equivalent type are recommended to be used.
● Wires and components must not be plugged into output sockets, and the toy must not be connected
to the power sources which are more than the recommended quantity.
● Do not expose battery to sun, or drop it. Keep the battery away from fire, heat and water.
● Skin and clothing to be washed immediately if you make contact with leaked liquid from the battery.
● For better preservation of rechargeable batteries, please regularly recharge it. Only a charger of the
same or equivalent type is recommended to be used.
ATTENTIONS
1

CAR BODY / STICKERS
The engine, suspension and driver’s cab of the car are all black, the car body is red and the wheels
are painted in silver. The stickers will be displayed during the following assembly process, you can
also refer to the package drawing.
USE OF THE STICKERS FOR CAR BODY
CAR BODY
(1)Take the stickers out.
(2)Carefully peel the sticker off with tweezers.
(3)Hold the edge of the back plate and put the sticker on the model.
(4)Fix the sticker with fingers and make the sticker in place.
(5)Gently press the sticker downwards until the bubbles disappear.
COMPONENTS
INSTALLED PROCEDURES FOR Lamborghini Sián FKP 37
(1) Take all parts out and make sure nothing is missing.
(2) Do not remove all the parts at first, but just do assembly step by step according to instruction of the
manual.
(3) Take the stickers out and stick them on components first according to the instructions.
(4) Assemble the car according to the figure.
(5) Assembly process is completed.
3