Rave Sports SUP User manual

RAVE® SUP
STAND UP PADDLE
BOARD
User Guide/Owner’s
Manual
WWW.RAVESPORTS.COM

2
Table of Contents
Warnings ...................................................................... ..3
Set up ........................................................................... ..4
Vent plug ...................................................................... ..4
Cargo net installation .................................................... ..4
Elastic Cargo Strap installation ..................................... ..5
Fin installation .............................................................. ..6
Leg leash installation .................................................... ..7
Paddle adjustment ........................................................ ..8
Paddling technique ....................................................... ..9
Installing Expedition carry handle…………... ................ 10
Cross Fit Board paddle wraps…………………………….11
Cleaning, storage and repair ........................................ .12
Transportation .............................................................. .12
Registration .................................................................. .11
Warranty ....................................................................... .12
Water sports can be safe and fun for all levels of
enthusiasts. The Owner’s Manual is presented to enhance
your enjoyment of the sport. It is intended to alert you to
some of the potentially dangerous conditions that can
arise in all water sports.
Copyright © 2017
All rights reserved. No part of this publication may be reproduced or transmitted in any
form or by any means, electronic or mechanical, including photocopy, recording, or any
information storage and retrieval system, without permission in writing from the
publisher. Requests should be mailed to RAVE Sports, 985 Aldrin Drive #301 Eagan,
MN 55121. 800.659.0790

3
W A R N I N G
• This product is not a lifesaving device. Adhere to local
regulations regarding life vest usage while on board this
product.
• Not for use by children except under mature, adult
supervision.
• Use this product only if you are in good health and know how
to swim. You are in charge of your own safety and the
safety of others around when using this product.
• Maintain a safe distance to other objects, including other
paddlers.
• Never use this product near boat traffic or other watercraft.
• Dress appropriately for weather conditions: cold water
and/or cold weather can result in hypothermia.
• Jumping onto or off of this product or rough play may result
in serious injury or death. Be aware of the possibility of
injury and act responsibly.
• Never paddle alone.
• Never use this product in conditions that are beyond your
ability. Be aware of water levels, locations of dams/rocks or
other underwater objects, tidal changes, dangerous currents,
weather changes and other hazards.
• Do not use in severe weather or when chance of lightning is
present.
• For use in water only. Never use on snow or tow from a
boat or other motorized vehicle.
• Do not use under the influence of drugs, alcohol or
medications which could alter your alertness.
• Check your equipment prior to each use for signs of damage
or potential failure.
!!

4
USE OF THIS PRODUCT AND PARTICIPATION IN THE SPORT OF
STAND UP PADDLEBOARDING INVOLVES INHERENT RISKS OF
INJURY OR DEATH.
Introduction
At RAVE SUP we live & breathe stand up paddle boarding. We’re all about
creating quality constructed SUP boards, paddles, and accessories that
embrace the SUP lifestyle.
Set Up
RAVE SUP boards include a removable fin, elastic cargo strap or net
(depending on model) and self-venting pressure relief valve. It is important
to understand how to properly install and remove these parts to prevent
damage to the equipment.
Self-Venting Plug
1. RAVE SUP boards come with a self-venting
plug installed. The vent plug allows the board to
regulate pressure inside the board due to
changing temperatures. CAUTION: Keep
board away from prolonged exposure to
direct sunlight or extreme heat when not in
use in order to prevent potential damage to
the deck pad and other surfaces.
2. The vent plug is fully installed by the factory.
There is no need to touch it. If it should happen
to come loose , hand tighten with a 5/8” socket.
Very lightly turn the plug clockwise until snug.
IMPORTANT: DO NOT OVER TIGHTEN. OVER
TIGHTENING WILL CAUSE THE THREADS
TO STRIP
1.
2.

5
Cargo Net
Installation
Replacement Cargo Net:
#20870
To install your cargo net,
take one of the loops
located on each corner of
the net and slip the loop through the desired tie down on the deck of your
board.
After the loop has been
pushed through the tie
down, pull it up and
around the button & pull it
snug. Repeat for all
corners.
Elastic Cargo Strap Installation (if equipped)
Replacement cargo strap: #20929
1. Insert loop end through the tie down on the top deck of your board.
2– 3. Pull it up and around the barrel button and pull it snug.
4. Repeat for other end.
1
2
3
4

6
Fin Installation
Screw & Nut plate is already installed onto SUP Board.
Step 1: Untighten screw and slide nut plate to the front of fin box and remove screw.
Step 2: Insert the pin end of the fin into the center slot of the fin box. NOTE: The fin
mounting hole should be facing towards the front of the board.
Step 3: Push down and slide fin to the back of the fin box. Ensure the fin is flush with the
bottom of the board as shown in Fig. 5.
Step 4: Align the screw hole on the fin and the nut plate.
Step 5: Usingfingers only, start screw into nut plate. Tighten with screwdriver to snug.
NOTE: DO NOT OVER TIGHTEN
1
2
3
4
3
5

7
Leg Leash (Not Included) Installation to SUP Board
(see next page)
Ankle leashes are important to wear if you are an inexperienced paddler,
when you are paddling alone, paddling in windy & wavy weather conditions,
in the strong current or surf.
Install the leash by grabbing the end opposite of the ankle strap.
Pinch the small cord and run it through the leash plug located on the
topside tail end of your board.
After the cord has been pulled through the leash plug take the end that
straps to your ankle and run it through the string loop until tight.
1
2
3
4
5
6

8
How to Attach the Leg Leash to Your Ankle
Open the Velcro
ankle attachment and
wrap it around each
side of your ankle,
then overlap it until
snug. Make sure all
Velcro flaps are
secured.
Paddle Adjustment
All RAVE paddles come assembled. To adjust the paddle, follow the steps
below.
There are two types of adjustment levers on
RAVE’s SUP paddles, the Qwik Snap & the
Qwik Levr.
For the Qwik Snap adjuster, pull center
section forward, align a hole to the top of the
collar and press back down to lock it in
place.
For the Qwik Levr, lift lever, adjust to desired length and press lever back
down to lock it in place. If you need to increase locking force, simply twist
the lever clockwise when open then lock back down.
1
2
3
4
1
2
Qwik Lever
Qwik Snap
1
2
3
4
5
6

9
When adjusting your paddle generally, the paddle height should be 8-10
inches above the paddler’s height. Starting with no shoes on and arm
raised, your paddle handle should sit in your palm.
Properly Holding the Paddle
Hold the paddle so the blade is angling towards
the front of the board as shown at right.
Place one hand cupped over the top of the T-
handle and the other hand approximately 2 feet
down the shaft or where it is comfortable.
How & Where to Stand on Your SUP Board
Start by climbing on the center of the board with your
knees placed on either side of the handhold facing
towards the nose of the board.
Once comfortable you may stand by placing both hands
on the board, then lifting one leg after another until
upright.
Finally make sure your feet are placed directly on either
side of the handhold, spread out a bit wider than shoulder
width.
Using the Board
• Start on your knees and push up to feet while centered on
the board.
• Feet should be shoulder width apart with slightly bent knees.
• Face forward with shoulders back.
Correct
Incorrect
1
2
3
4
5

10
• Reach over with your top hand to keep paddle as vertical as possible and use
short, straight strokes along the side of the board. Look forward, not down.
• With practice, you will be able to take many strokes on the same side of the board
before switching to the other side.
• NOTE: Stability is increased when paddling. Paddle through chop and waves for
more control.
• To turn on the SUP board, paddle on the opposite side you desire to turn. Use
outward sweeping motion to turn quicker.
Installing Carry Handle on Expedition boards
Replacement handle item: #20930
Note: This applies only to Expedition boards ES126 & ES140

11
Magnetic Paddle Wraps (For Core Crossfit SUPs only)
1. Place the paddle wraps over the magnetic points of the board to find
the proper width along the paddle shaft.
2. When the wraps are laid in position, place the paddle in the groove.
After the paddle is in the desired position continue with number 3 – 5.
3-5. Wrap the Velcro and secure the wrap onto the paddle. Once the wrap
is attached, the tab of the Velcro should always be facing up when
the paddle is placed down into the groove.
6. The paddle lays neatly in the paddle groove until use.
Warning
Do not place smart phone or any device that may be sensitive to magnets.
Magnetic fields can temporarily interfere with the digital compass and
magnetometer inside your smartphone. Do not place credit cards or
anything with a magnetized strip close to the magnetic wraps or magnetic
points of the board.

12
Cleaning and Storage
• Use warm soapy water and clean with sponge or soft brush.
• To remove scuffs from your paddleboard, use the rough side of a basic sponge (Do
Not Use Steel Wool), dip it in warm soapy water then scrub in a circular motion until
all marks are removed (Follow by rinsing).
• When not being used, we recommend that you store it in a covered, shaded area.
This will help protect it against ultraviolet (UV) rays and extend the life of the
product.
• Secure the product to prevent unauthorized or unsupervised use.
• Do not leave board in direct sunlight for long periods of time when not in use.
Repairs
• To repair cracks or breakage of the board’s fiberglass surface use marine resin
epoxy to patch and fill the damaged area. (Make sure to follow the manufacturer’s
instructions when using and applying any product). Use epoxy resin repair products
only. Do not use polyester resins or other fillers.
• To repair a deck pad bubble, puncture it with a pin and press the air out of it until flat.
To repair a tear in the deck pad make sure it is dry then dab some super glue under
the damaged area and press it down until secured.
Transportation
When transporting your equipment make sure to use proper tie down straps to secure
your board. (Do Not Use Ratchet Straps) To purchase proper straps and pads visit
www.ravesup.com.
When placing a board on your car flip it upside down with the deck pad and curvature of
the board facing down towards the roof of the car. The tip or the tail of the board may face
forward but it is preferred to have the tail facing forward in most instances.
Watercraft Registration
Check with your local licensing bureau regarding watercraft registration requirements for
your SUP, if any. If you are required to license your paddleboard, you will need to provide
a serial number, which is located at the back of the board, usually adjacent to the fin box.
Note: on some soft top SUPs, the serial number is located at the bottom of the recessed
handle pocket.

13
To affix the registration sticker to your SUP, clean the area with isopropyl alcohol where
the registration stickers will be applied. Dry completely before affixing the registration
stickers.
On RAVE soft top SUPs, the watercraft registration panel is
embedded onto the top surface of the board near the tail.
Clean with alcohol and dry, then affix both watercraft
registration stickers onto this panel, as shown.
RAVE Sports® Limited One Year Warranty
RAVE Sports® provides a limited manufacturer’s warranty for defects on all
new boards for one (1) year from date of purchase. This warranty covers
only RAVE Sports® boards that are purchased from an authorized RAVE®
Dealer. This warranty applies only to the original purchaser and may not be
transferred. Proof of purchase must be presented at the time of the
warranty claim. This warranty does not cover any damage that may be a
result of normal wear and tear, misuse of the product, unauthorized
modification or repairs, accidents, heat, excessive exposure to sunlight,
improper handling, storage, abuse, maintenance or care, incorrect set-up,
use in commercial, rental or teaching environments, or any other
irresponsible use. Cosmetic flaws do not affect the functionality and
performance of the board and are not applicable. If you have a question
regarding your warranty please contact customer service.

14
Available accessories that are also offered by RAVE Sports.
Check out our website at www.ravesports.com for more options.

15

16
WWW.RAVESPORTS.COM
RAVE SPORTS
A Revel Match, LLC Company
985 Aldrin Drive #301
Eagan MN, 55121
800.659.0790
June 2017