Rave Sports Aqua Buddy User manual

Aqua Buddy™
Owner’s Manual
www.ravesports.com
Meijer.com

1
Table of Contents
Product instructions and warnings...........................................2
Instructions on how to use product……………………………….....3
Water sports safety code...........................................................5
Inflating instructions .................................................................8
Troubleshooting.........................................................................9
Cleaning and storage.................................................................9
Repairs........................................................................................9
Water sports can be safe and fun for all levels of enthusiasts.
The Owner’s Manual is presented to enhance your enjoyment
of the sport. It is intended to alert you to some of the
potentially dangerous conditions that can arise in all water
sports.
Copyright ©
All rights reserved. No part of this publication may be reproduced or transmitted in any form
or by any means, electronic or mechanical, including photocopy, recording, or any information
storage and retrieval system, without permission in writing from the publisher. Requests
should be mailed to RAVE Sports, 3325 Labore Road, Saint Paul, Minn 55110.
Meijer.com

2
W A R N I N G
USE OF THIS PRODUCT AND PARTICIPATION
IN THE SPORT INVOLVES INHERENT RISKS OF
INJURY OR DEATH.
This tube is designed for use as a water sports trainer only.
Read Owner’s Manual before use.
Product Instructions and Warnings
To reduce the risk of injury or death using the Aqua Buddy, follow
these guidelines:
•Carefully read this manual and follow the instructions.
•Only use your Aqua Buddy with a responsible watercraft
operator who knows how to operate a watercraft properly.
Before you start:
•Scout the area before use to avoid any debris or obstacles that
might present a safety hazard.
•Check the rope and connectors for frays, cuts, sharp edges,
knots, or wear before each use. Discard rope if any such
condition exists or if rope appears to be worn. Such conditions
may lead to breaks.
•Rope is subject to deterioration when exposed to direct sunlight.
The life of the product will be extended when stored away from
sunlight.
!
!
Meijer.com

3
•Always have a person other than the driver as an observer.
•Skier/rider, observer, and driver must agree on hand signals.
•Never start until skier/rider signals they are ready.
•Do not use in shallow water or near docks, shore, pilings or
other watercraft.
•Always wear a U.S. Coast Guard approved type III (PFD) life
jacket that fits skier/rider properly.
•Make sure skier/rider has properly fitting bindings.
•Use tow rope that is 50-65 feet long and do not shorten rope for
beginning riders.
Directions on how to start with the Aqua Buddy:
1. Rider needs to first put on water skis or wake board.
2. To load the Aqua Buddy the rider must pull themselves
onto the seat using the handles.
3. Have the boat driver or spotter hand the rope to rider.
4. Slowly remove any slack in the rope and be sure that the
boat and rider are facing the same direction.
5. Rider must keep skis straight or wakeboard at about a 45
degree angle to the boat. Rider must be facing the back of
the boat.
6. Once the rider signals to the spotter they are ready the
driver can take off. (take off speed depends on weight and
strength of rider)
7. It is best to start going and not drag the rider. (dragging
rider causes fatigue and causes the rider to veer off course)
8. Once the rider is moving fast enough to stand up its time to
ski/ride. The Aqua Buddy will stay behind once the rider
takes their weight off of the seat.
Meijer.com

4
This Product acts as a dock start but safer because there is not
anything hard for the rider to strike. The Aqua Buddy is also easier to
learn on since the seat moves along with the rider until they are ready
to stand up.
W A R N I N G
USE OF THIS PRODUCT AND
PARTICIPATION IN THE SPORT OF
SKIING/WAKEBOARDING INVOLVES
INHERENT RISKS OF INJURY OR DEATH
!!
Meijer.com

5
W A R N I N G
Do not use at speeds that exceed the skill of the
rider.
This product should never be used by children
except under adult supervision.
This is not a personal flotation device.
Always wear a U.S. Coast Guard approved Type III
(PFD) vest.
Always have a person other than the driver
observing the rider.
Watercraft driver should avoid excessive speed or
sharp turns that might cause the rider to lose
control, resulting in serious injury to the rider.
Do not tow in shallow water or near shore, docks,
pilings, swimmers or other boats.
Water Sports Responsibility Code
Water sports are fun and challenging but involve inherent risks of
injury or death. To increase your enjoyment of the sport and to
reduce your risks, use common sense and follow these rules.
Familiarize yourself with all applicable federal, state and local
laws, the risks inherent in the sport and the proper use of the
equipment.
Before you start:
Know the waterways.
!
!
Meijer.com

6
Always have a person other than the boat driver as an observer.
Rider, observer and driver must agree on hand signals.
Never start out until rider signals he/she is ready. Observer and
rider should maintain eye contact.
Carbon Monoxide (CO) poisoning from engine exhaust may
cause injury or death. Do not sit on the boat transom or swim
platform while the engine is running. These activities may lead
to excessive CO exposure which may cause injury or death. If
you can smell engine exhaust while in the boat, do not stay
seated in that position for prolonged periods. Never “Platform
Drag” by holding onto the swim platform or be dragged directly
behind the boat. An improperly tuned engine will produce
excessive exhaust. Have your engine checked and corrected by a
mechanic. Changing boat speed or direction relative to the wind
can reduce or increase boat exhaust from accumulating near the
boat and rider. Consult your boat Owners Manual, or the United
States Coast Guard’s website: www.uscgboating.org for more
information on how to help protect others and yourself from the
dangers of CO poisoning
Use caution and common sense.
Inspect all equipment prior to use. Check Aqua Buddy and
skis/wakeboard prior to each use. Do not use if damaged.
Your Equipment and Your Tow Rope:
Always wear a U.S. Guard Type III (PFD) vest.
Ropes should be attached to the watercraft in an approved
fashion with hardware designed for pulling. Refer to your
watercraft manual for instructions on proper tow rope
attachment.
Meijer.com

7
Tow ropes stretch during use. If a rope breaks or is suddenly
released, it can snap back into the watercraft. Warn all riders
and occupants of the danger of the rope recoil.
When in the boat, keep away from the tow rope to avoid injury.
Passengers can be hit or become entangled in the rope.
Inspect tow rope and its attachments before using. Do not use
tow rope if frayed, knotted or damaged. Replace when signs of
excessive deterioration are indicated by discoloration, broken
filaments, unraveling or other obvious signs of wear on the rope
or hardware.
Use proper tow rope for the activity.
Ensure rope is clear of all body parts prior to starting out or
during use.
Keep persons and ropes away from propeller when engine is
running, even in neutral. Should rope become entangled in
propeller, SHUT OFF ENGINE AND REMOVE IGNITION KEY
BEFORE RETRIEVING ROPE.
USE THIS PRODUCT ONLY ON WATER.
When You Ride:
Always remove any slack in the rope between watercraft and
rider before starting. Sudden shock loads may cause injury to
the rider or failure of rope, resulting in snap-back or breakage.
Do not ride in shallow water, near shore, pilings, docks, rafts,
swimmers, other boats or other obstacles. Such obstacles are
examples of risks that are inherent in the sport.
The driver and rider must watch for and be able to stop or turn
to avoid obstacles.
Meijer.com

8
Always ride in control and at speeds appropriate for your ability.
Ride within your limits. Follow instructions on tube for safe
speed limits.
Falling and the injuries that may result are inherent risks in the
sport.
Use a flag to signal to others that a rider is in the water.
Driver must use extra caution approaching fallen rider and keep
eye contact on fallen rider at all times.
Put the boat in neutral when near a fallen rider. Turn the engine
off when people are getting in or out of the boat, or while in the
water near the boat.
Do not operate watercraft or ride under the influence of alcohol
of drugs.
Inflating Instructions
CAUTION: DO NOT OVER-INFLATE. Use of an air compressor or over-
inflation can rupture the tube beyond repair, thus voiding the warranty.
Step 1
Lay Aqua Buddy on a flat surface. Make sure there are no sharp
objects under the product that might puncture the tube.
Step 2:
Inflate both pontoons then center seat till tube feels firm. DO NOT
OVER INFLATE.
NOTE: Moisten the plug of the clear stem valves prior to inserting into the
valve and push plug down into the valve body fully.
Meijer.com

9
To Deflate
•Remove all of the plugs and place deflating straws into valves.
Troubleshooting
Air chamber(s) won’t hold air:
•Check stem valves to ensure plugs are fully seated down into the
valve body.
•Check for holes in bladder following the procedures in the
“Repair” section.
Cleaning and Storage
When the inflatable product is not being used, we recommend
that you store it in a covered, shaded area. This will help protect
it against ultraviolet (UV) rays and extend the life of the product.
Clean the inflatable completely with a mild soap and fresh water.
NEVER USE PETROLEUM BASED PRODUCTS OR SOLVENTS FOR
CLEANING.
Product should be completely dry and remain dry while stored.
Roll the product loosely and place in a vented storage bag or
container.
Store in a cool, dry location. Do not store product directly on
concrete surface. Place mothballs around stored inflatable to
keep mice and insects away.
Repairs
Additional repair patches can be purchased at www.ravesports.com.
For minor holes or tears:
Inflate the tube and locate the leak by spraying the tube with
soapy water. Bubbles will appear where there is a leak.
Determine the hole size and cut a circular patch ½ - 1 inch wider
than the hole.
Meijer.com