RAX AJ-24 Product information sheet
AJ-24 SPEAKER STAND
Easy Assembly Instructions
May we take this
opportunity to thank
you for purchasing the
AJ-24 speaker stand.
We strongly suggest
that you carefully
study these assembly
instructions before
attempting to assemble
the unit, and that you
observe the listed
precautions.
R
CAUTION
SUITABLE FOR SMALL TO MEDIUM SIZE SPEAKERS.
DO NOT OVERLOAD THE STANDS.
Contact the Acoustic Solutions Helpline on 01327 340601 for any replacement items. This line
is manned from 9:00am until 4:30pm, Monday to Friday.
REV: 1/046/1.3
Please read these precautions before assembling and using this unit.
Take care when unpacking to avoid damaging parts.
Do not overtighten the wood screws.
Do not use abrasive cleaners, use only a damp cloth to clean.
1
2
3
Component parts and ttings contained in the box
Fittings
Wood Screws x 16
Part No Name Quantity
A Top plates 2
B Bottom plates 2
C Column side plates 4
D Plastic cable cover
strips
2
E Spiked feet 8
F Isolation pads 8
Tools needed
Pozidrive screwdriver (not included)
AB
C
D
C
E
F
Please Note: Specications of parts are subject
to change without notice. E&OE
Remove all parts from the carton and inspect
them. If you nd any damaged or missing parts
please contact the Acoustic Solutions Help Line
on 01327 340601 for replacements. This line is
manned from 9:00 am until 4:30 pm .
Tools needed
Pozidrive screwdriver (not included)
ASSEMBLY
1Group one top plate (A),
one base plate (B) and
two column side plates
(C) together with 8 wood
screws (as shown on page
1)
3With the column side plates
xed to the base plate, slide
the plastic cable cover strip
(D) down the slots to the
rear of the column sides.
Using 4 wood screws, align
the holes in the base plate
with the pre-drilled holes
in each column side plate.
Note that the rounded
edges of the column side
plates should face the
front, wider edge of the
base plate. Tighten screws
evenly.
4Using 4 woodscrews, align
the holes in the top plate
with the pre-drilled holes
in each column side plate.
Tighten screws evenly.
2
3
5
5Fit 4 self-adhesive isolation
pads (F) to the outer
corners of the top plate (A).
ASSEMBLY
Note - the spiked feet may
make slight indentations
in wooden oors or other
oor coverings, and could
cause injury.
Repeat from step 2)
onwards for the second
stand.
7
Set the speakers on the
stands and run the speaker
cable either through the
gaps at the top and bottom
of the cable cover strip, as
shown in 8A, or through the
hole in the base plate as
shown in 8B. Ensure the
speakers are balanced on
the stands.
8
6Fit 4 spiked feet (E) into
the holes in the bottom of
the base plate. The spiked
feet are threaded, it is
necessary to screw them
into the corresponding
holes on the base plate.
The spiked feet are
optional, to provide isolation
between the stands and the
oor, as well as to provide
stability on carpet.
6
8A
B
8
