Raymarine St290 User manual

ST290 Data Display - quick reference guide
ST290 Data Display Alarm pages
Alarm pages enable you to set alarm modes & thresholds
How to see Alarm pages
1. Enter the ALARMS chapter
D6305-1
You can use alarm pages to:
Set the threshold of each Alarm, to define when the Alarm will operate.
Set the operating mode of each Alarm, either OFF, ON or for operation with
an Auxilliary (external) alarm unit.
Note: Where examples are required, this guide uses the High Apparent Wind Angle Alarm. The principles are valid for all Alarms.
Note: This example shows how to see
FAVORITE pages in the upper display area.
The same principles are valid for the lower
display area.
ALARMS
SPEED KTS
2. Select the Alarm page you want
SHALLOW
alarm DEEP alarm
SHALL.
ANCHOR
alarm
OFF
COURSE
alarm
AWA
LOW
alarm
AWS
HIGH
alarm
AWS
LOW
alarm
TWA
HIGH
alarm
TWA
LOW
alarm
LO SEA
TEMP
alarm
TWS
LOW
alarm
DEEP
ANCHOR
alarm
TWS
HIGH
alarm
SPEED
LOW
alarm
SPEED
LOW
alarm
AWA
HIGH
alarm
1 s
Note: This illustration shows the Alarm pages available in an
ST290 Full Profile. If a different profile is selected, some Alarm
pages may not be available.
HI SEA
TEMP
alarm
All Alarm pages display
Anchor Alarm pages also display
ST290 Data Display - quick reference guide
ST290 Data Display Alarm pages
Alarm pages enable you to set alarm modes & thresholds
How to see Alarm pages
1. Enter the ALARMS chapter
D6305-1
You can use alarm pages to:
Set the threshold of each Alarm, to define when the Alarm will operate.
Set the operating mode of each Alarm, either OFF, ON or for operation with
an Auxilliary (external) alarm unit.
Note: Where examples are required, this guide uses the High Apparent Wind Angle Alarm. The principles are valid for all Alarms.
Note: This example shows how to see
FAVORITE pages in the upper display area.
The same principles are valid for the lower
display area.
ALARMS
SPEED KTS
2. Select the Alarm page you want
SHALLOW
alarm DEEP alarm
SHALL.
ANCHOR
alarm
OFF
COURSE
alarm
AWA
LOW
alarm
AWS
HIGH
alarm
AWS
LOW
alarm
TWA
HIGH
alarm
TWA
LOW
alarm
LO SEA
TEMP
alarm
TWS
LOW
alarm
DEEP
ANCHOR
alarm
TWS
HIGH
alarm
SPEED
LOW
alarm
SPEED
LOW
alarm
AWA
HIGH
alarm
1 s
Note: This illustration shows the Alarm pages available in an
ST290 Full Profile. If a different profile is selected, some Alarm
pages may not be available.
HI SEA
TEMP
alarm
All Alarm pages display
Anchor Alarm pages also display

Document number: 86085-1
Use with: ST290 Instrument System Owner’s Handbook
Date: 15 May 2003
Document number: 86085-1
Use with: ST290 Instrument System Owner’s Handbook
Date: 15 May 2003
ST290 Data Display Alarm pages
How to adjust Alarm levels
Repeat steps 2 to 5 for each Alarm you
want to set up.
6.
3.
to enter setup mode.
Hold down for 1 s
to set the alarm value
you want
orUse
4.
to leave setup mode and
save the alarm value you
have set.
Hold down for 1 s
5.
1.2.
How to set the Alarm mode
Switch the alarm OFF Switch the alarm ON
Set the alarm to
operate with an
Auxilliary alarm unit
1.
Use to select the
Alarm you want to set up
2.
3.
D6306-1
ALARMS
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
ALARMS
SPEED KTS
Use to select the
Alarm you want to set up
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
Auxilliary alarm
indicator
ST290 Data Display Alarm pages
How to adjust Alarm levels
Repeat steps 2 to 5 for each Alarm you
want to set up.
6.
3.
to enter setup mode.
Hold down for 1 s
to set the alarm value
you want
orUse
4.
to leave setup mode and
save the alarm value you
have set.
Hold down for 1 s
5.
1.2.
How to set the Alarm mode
Switch the alarm OFF Switch the alarm ON
Set the alarm to
operate with an
Auxilliary alarm unit
1.
Use to select the
Alarm you want to set up
2.
3.
D6306-1
ALARMS
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
ALARMS
SPEED KTS
Use to select the
Alarm you want to set up
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
AWA HIGH
SPEED KTS
Auxilliary alarm
indicator