RC4WD Z-E0130 User manual

100-0114
Step 4.
Step 2.Step 1.
1
Wireless Warn Winch
Instruction Manual
100-0114
Step 7.
Step 6.Step 5.
Check operation of the winch.
2
Wireless Warn Winch
Instruction Manual
Step 3.
Plug the battery into the power connection wire.
Push and hold the bind button on the wireless control
box while plugging in the battery connection.
Plug the winch control box plugs into the control box
marked W+/W-. Check for proper insertion, with the
red plug going to (+) and the black plug to (-).
Connect the winch plug into the winch/control box
plug.
Flip the switch on the back to turn it on.
Install lanyard here.
Push and hold both buttons on the TX to allow binding
to take place.

100-0114
Step 8.Step 7.
Step 6.Step 5.
To install a new battery, pull the currently installed
battery out.
*Note: CR2025 3V Lithium Battery.
Reinstall the rear case and install the two screws
with the Phillips screw driver.
When installing the new batteries, make sure they
are in the proper configuration. Positive facing up,
and negative facing down.
Install the battery by pushing it into the circuit board,
making sure to not use too much force.
4
Wireless Warn Winch
Instruction Manual
100-0114
Step 4.Step 3.
Step 2.Step 1.
Use Phillips screwdriver to remove the screws. Remove the case back.
Use some small force to remove the battery box.
Wiggle the circuit board back and forth making
sure to keep it flat/horizontal with the case
front. This process is very important to raise
the electronic board just enough to remove the
battery. You do not need to fully remove the
circuit board.
3
Wireless Warn Winch
Instruction Manual
150-0352
150-0352
+
-
+
+
150-0352
150-0352