Red Arrow Trading FLAC10BPIR-31 User manual

SPECIFICATION
INSTALLATION INSTRUCTIONS
LED AC DRIVERLESS
FLOODLIGHTS WITH PIR
FOR MODEL: FLAC10BPIR, FLAC10BPIR-31, FLAC20BPIR,
FLAC20BPIR-31, FLAC30BPIR, FLAC30BPIR-31, FLAC50BPIR &
FLAC50BPIR-31
T: 0800 195 0006 F: 0870 195 0006
E: [e-mail]
www.redarrowtrading.com
INTRODUCTION
The LED AC Driverless Floodlights
with PIR include a hanging /
mounting bracket and a 100cm
cable.
10W-
50W
180-
240V
IP65
LED
IK07
3100K/
6000K >80 Ra
750-
4000lm 50Hz
• Dimensions:
10W: L: 103 x W: 155 x D: 50mm
20W & 30W: L: 160 x W: 193 x D: 52mm
50W: L: 206 x W: 216 x D: 54mm
• LED: 15-80pcs of SMD 2835
• Working Temperature: -20°C - 45°C.
Automatic
Circuit Breaker
Type
B6 B10 B13 B16 B20 C10 C13 C16 C20
Rated
Current
(Ampere)
6A 10A 13A 16A 20A 10A 13A 16A 20A
Installation
(mm²)
1.5 1.5 1.5 1.5 2.5 1.5 1.5 1.5 1.5
10W 132 220 286 352 440 220 286 352 440
20W 66 110 143 176 220 110 143 176 220
30W 44 73 95 117 146 73 95 117 146
50W 26 44 57 70 88 44 57 70 88
PIR Specification
• Voltage: 220-240V 50/60Hz
• Rated Load: Maximum 100W resistive load /
Maximum 10W inductive load
• Detection Range: 90°
• Detection Distance: 6-10m (adjustable)
• Time Delay: Minimum 10±5 seconds, maximum 8±2 minutes
(adjustable)
021019
Red Arrow Electrical Distribution
Elsworth House, Herries Road South
Sheeld, S6 1QS

INSTALLATION INSTRUCTIONS
IMPORTANT: Ensure that ALL electrical connections are tight
with no loose strands, including factory made connections.
1. Ensure there is adequate free air circulation of at least 100mm
around the fitting. All fittings run hot. It is the installer’s
responsibility to consider any fire risk and take appropriate
precautions.
2. The nearest illuminated surface must be at least 0.5m from
the front of the fitting.
3. Check for concealed cables before drilling any fixing holes.
4. Remove the bracket by removing the two bolts.
5. Fix the bracket to a wall or similar hard surface.
6. Fix the body to the bracket using the two bolts.
4TH WIRE INSTALLATION INSTRUCTIONS
This LED AC Driverless Floodlight with P.I.R is equipped with a
4th wire (Brown). This wire can be used as follows:
Connected to a switch (as per diagrams on reverse), when
switched on will bypass the PIR and the LED AC Driverless
Floodlight will remain on until switched o.
INSTALLATION INSTRUCTIONS
T: 0800 195 0006 F: 0870 195 0006
E: [e-mail]
www.redarrowtrading.com
SAFETY WARNING
• The installation should be carried out by a qualified electrician in compliance with the current edition
of the IEE Wiring Regulations.
• Prior to installation carry out the necessary risk assessment considering the people who could be at
risk, the level of risk and the precautions required to control the risk.
• Ensure that the circuit supply is isolated either by the circuit supply fuse being removed or the
applicable circuit breaker being turned o before installation or any maintenance.
• Check the total load on the circuit including the luminaire does not exceed the rating of the circuit
cable, fuse or circuit breaker.
• If the fitting incorporates control gear, ensure careful sizing to avoid instances of nuisance tripping of
the protective device used in the installation.
• Follow the provided installation instructions, using the fixings supplied or recommended.
BOX CONTENTS
1 x LED AC Driverless Floodlight with PIR
• Ambient Light: 2-2000lux (adjustable)
• Detection Motion Speed: 0.6-1.5m/s
• Working Temperature: -10°C - 40°C
• Installation Height: 1-3m
FOR MODEL: FLAC10BPIR, FLAC10BPIR-31, FLAC20BPIR,
FLAC20BPIR-31, FLAC30BPIR, FLAC30BPIR-31, FLAC50BPIR &
FLAC50BPIR-31
LED AC DRIVERLESS
FLOODLIGHTS WITH PIR
Red Arrow Electrical Distribution
Elsworth House, Herries Road South
Sheeld, S6 1QS

EARTH: GREEN / YELLOW
LIVE: BLACK
NEUTRAL: BLUE
SWITCH LIVE: BROWN
INSTALLATION INSTRUCTIONS
T: 0800 195 0006 F: 0870 195 0006
E: [e-mail]
www.redarrowtrading.com
FOR MODEL: FLAC10BPIR, FLAC10BPIR-31, FLAC20BPIR,
FLAC20BPIR-31, FLAC30BPIR, FLAC30BPIR-31, FLAC50BPIR &
FLAC50BPIR-31
NOTE: If the 4th (Brown) wire is not required it must be termi-
nated safely, when the PIR is activated it will become live.
LED AC DRIVERLESS
FLOODLIGHTS WITH PIR
Red Arrow Electrical Distribution
Elsworth House, Herries Road South
Sheeld, S6 1QS

INSTALLATION INSTRUCTIONS
T: 0800 195 0006 F: 0870 195 0006
E: [e-mail]
www.redarrowtrading.com
TESTING THE PIR
• Turn the SENS dial anti-clockwise to the maximum point, turn
the TIME dial clockwise to the minimum point, turn the
LUX dial clockwise to the Sun.
• When you switch on the power, the fitting will not illuminate.
After a 30 second pre-heat, when the sensor gets the
induction signal, the load will turn on. Once the load switches
o, it will then turn on again after 5-15 seconds of the sensor
receiving an induction signal.
• After the sensor goes o, trigger the detection field after
5-10 seconds. The load should work. When there is no
induction signals in the sensor, the load should stop working.
• Turn the LUX dial anti-clockwise to the Moon. If it
is adjusted to less than 3 LUX (dark), the load and sensor
should not work when testing in daylight. If you cover the
detection window with an opaque object, the load should
work. Under no induction signal condition, the load should
stop working within 5-15 seconds.
NOTE: WHEN TESTING IN DAYLIGHT, PLEASE TURN THE LUX
DIAL TO THE (SUN) POSITION, OTHERWISE THE SENSOR
WILL NOT WORK!
TROUBLESHOOTING
THE SENSITIVITY IS POOR:
• Please check if there are any objects in the detection field.
• Please check if the ambient temperature is too high.
• Please check if the installation height corresponds to the
height shown in the instructions.
FOR MODEL: FLAC10BPIR, FLAC10BPIR-31, FLAC20BPIR,
FLAC20BPIR-31, FLAC30BPIR, FLAC30BPIR-31, FLAC50BPIR &
FLAC50BPIR-31
LED AC DRIVERLESS
FLOODLIGHTS WITH PIR
Red Arrow Electrical Distribution
Elsworth House, Herries Road South
Sheeld, S6 1QS

MAINTENANCE
• Depending on the application, clean the glass cover at
regular intervals, and remove all dust or dirt to ensure the
fitting works correctly.
• Use a cotton duster (no alcohol, no solvent) and water only
to clean the glass.
• Before any maintenance ensure the product has cooled
down.
• This product is supplied ready to use. No maintenance should
be required, except if damaged or the front glass cover is
broken. In either case please contact your supplier.
• The fixture can not be modified. Any modification to this
fitting will void the warranty.
• The manufacturer / importer shall not be responsible for any
product damages caused by mounting procedures which are
not in accordance with instructions.
ADDITIONAL INFORMATION
• Please note this is an IP65 rated product - do not break any
seals as this will aect it’s water resistant rating.
INSTALLATION INSTRUCTIONS
GUARANTEE
This product is guaranteed for a period of 2 years from the date of purchase. The guarantee is
invalid in the case of improper use, tampering, removal of the Q.C. date label, installation in an
improper working environment or installation not according to the current edition of the I.E.E.
Wiring Regulations (BS7671). The guarantee is also invalidated if the luminaire has been Mega
tested. Should this product fail during the guarantee period it will be replaced free of charge,
subject to correct installation and return of the faulty unit.
We do not accept responsibility for any installation costs
associated with the replacement of this product. Your
statutory rights are not aected. We reserve the right to
alter specifications without prior notice.
T: 0800 195 0006 F: 0870 195 0006
E: [e-mail]
www.redarrowtrading.com
• Please check if your direction of travel doesn’t create poor
sensitivity of the Sensor. (i.e. if you are walking towards the
fitting this creates poor sensitivity).
THE SENSOR CAN NOT SHUT OFF THE LOAD
AUTOMATICALLY:
• Please check if there is continual signal in the detection field.
• Please check if the time delay is at it’s maximum.
• Please check if the power corresponds to the instructions.
• Please check if the temperature near the sensor changes,
such as if there’s air conditioning or central heating.
FOR MODEL: FLAC10BPIR, FLAC10BPIR-31, FLAC20BPIR,
FLAC20BPIR-31, FLAC30BPIR, FLAC30BPIR-31, FLAC50BPIR &
FLAC50BPIR-31
LED AC DRIVERLESS
FLOODLIGHTS WITH PIR
Red Arrow Electrical Distribution
Elsworth House, Herries Road South
Sheeld, S6 1QS