RED5 FX 3in1 User manual

PLEASE READ INSTRUCTIONS CAREFULLY AND RETAIN FOR FUTURE REFERENCE
TRANSFORMING VEHICLE
Ages 8+

L
R
COMPONENTS
ASSEMBLY
RIGHT LEFT
POWER
SWITCH
-1-
Flexible mobile
phone holder
Photo
Shooting
One-button
ascending
Left control lever
One-button
descending
Headless mode
Jumping button
One-button return
Pilot light
Speed gear
Four-axis rolling button
Forwards
Right control lever
Backwards
Left
Right
Light mode controlling
Power switch
CONTROLLER

LEFT
RIGHT
FITTINGS INSTALLATION
Attach the bumper frame as shown in the
above picture.
Attach the propeller as shown in the above
picture and fasten with screws.
WARNING: Only use the charger and battery provided
with this product. The use of other chargers and
batteries may cause accidents or damage to the
product.
Insert the rechargable battery underneath the
fuselage as shown in the picture above.
Plug in the charger provided and charge the
battery.
JUMPING BIKE
Attach the wheels on each side of the
fuselage.
Attach the jumping frame by clipping it to
the points either side of the fuselage.
Attach the third clip to the underneath of
the fuselage.
Press the jumping button on the controller.
The spring on the jumping frame will
compress.
The spring will release and launch the
jumping bike into the air.
Note: Please do not press the one-key take-o button when the vehicle is not being used as a drone.
-2-
Remove the battery covers and install 4x AA batteries according to the correct polarity and replace battery cover.
CONTROLLER BATTERY INSTALLATION

1
2
Rolling Mode
LEFT
RIGHT
L
-3-
SPACE VEHICLE
Attach and fasten the wheels on each side of the fuselage.
PRODUCT FUNCTIONS
Startup Mode: Turn on the drone and the controller. Push the left control lever all the
way up to match the frequency. Pull it to the left, then down to the bottom to reset.
After resetting, move both control levers outwards and down as shown in the picture.
The drone is now ready to fly.
To perform an emergency stop, push both control levers in the direction shown in the
picture. The drone will stop immediately.
Press the rolling button and move the right control lever
in the desired direction to perform a roll.
Push both control levers to the right to calibrate the drone.
Left control lever: Altitude, left and right turns.
Right control lever: Forwards, backwards, fly left or right.
The jumping bike is controlled using the right control lever. It can move
in any direction but if pushed all the way to the left or right, the bike will
rotate 360°.
The space vehicle is controlled using the right control lever.
Altitude hold function.

NOTE
1. Ensure battery power is sucient.
2. Ensure controller and drone are paired.
3. Only y in a suitable environment away from people, animals and obstacles such as power cables.
Turn on WiFi on your device and connect with
the drone
WiFi range is over 60m
Flight range 100 - 120m
Drone charge time: 120 minutes Flight time: 10 - 12 minutes
Space vehicle charge time: 120 minutes Drive time: 30 minutes
Jumping bike charge time: 120 minutes Drive time: 30 minutes
HEADLESS MODE
In this mode the user does not need to specify the front or the back of the drone. It will fly according to the
directional controls of the user regardless of where the “front” of the drone is pointing.
E.g. If the “front” of the drone is pointing towards you and you operate the forward controls, the drone will fly
away from you.
ONE-KEY RETURN
When this button is pressed or the signal is lost, the drone will automatically return to the point of take-o.
-4-
Manufactured by The Source Wholesale
The Atruim, Curtis Road,
Dorking, Surrey RH4 1XA
Please retain the important information
on this packaging for future reference.
72095
MADE IN CHINA
Supplier item reference: H3
07/18
WWW.RED5.COM
Hereby, Gift Universe Management Ltd, declares this product is in compliance
with the essential requirements and other relevant provisions of Directive
2014/53/EU. A copy of the original Declaration of Conformity can be obtained at
the following address: Gift Universe, The Atrium, Curtis Road, Dorking Surrey
RH4 1XA.
This product bears the selective sorting symbol for waste electrical and
electronic equipment (WEEE). This means that this product must be handled
pursuant to European Directive 2012/19/EU in order to be recycled or
dismantled to minimize its impact on the environment. For further information,
please contact your local or regional authorities. Electronic products not
included in the selective sorting process are potentially dangerous for the
environment and human health due to the presence of hazardous substances.
BATTERY ADVICE
• Requires 4 x 'AA' batteries. Not Included.
• Batteries should only be replaced by an adult.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
• Do not re-charge non-rechargeable batteries.
• Rechargeable batteries are only to be charged under
adult supervision.
• Rechargeable batteries are to be removed from the
product before being charged.
• Ensure batteries are inserted with the correct polarity.
• Exhausted batteries should always be removed.
• The terminals should not be short circuited.
• Use a screwdriver to remove the screw from
the battery cover and insert batteries. Replace
battery cover and screw before use.
TECHNICAL SPECIFICATIONS