Redtiger T27 User manual

T27 USER MANUAL
Email: [e-mail]
Website: http://www.redtigercam.com
Phone: [phone] (US)
V04

WARNING: Be careful when using your
camera and its accessories. Always be
cautious of your surroundings to avoid
injuring yourself and others.
Make sure to follow all local laws including
all privacy laws which may restrict recording
in certain areas.

IC warning:
This device contains licence-exempt transmitter(s)/receiver(s)/
that comply with Innovation Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the
following two conditions:
1. This device not cause interference.
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
Radiation Exposure: This equipment complies with Canada
radiation exposure limits set forth for an uncontrolled environment.
To maintain compliance with IC's RF Exposure guidelines, this
equipment should be installed and operated with minimum distance
of 20cm the radiator your body. This device and its antenna(s) must
not be co-located or operation in conjunction with any other antenna
or transmitter.
Déclaration de l'ISED Canada:
Cet appareil contient des tasmittre (s) / récepteur (s) sans licence /
conformes à l'innovationRSS exemptes de licence de Sciences et
Développement économique Canada. L'opération est sous réserve
des deux conditions suivantes:
1. Cet appareil ne peut pas causer d'interférences et.
2. Cet dispositif doit accepter toute interférence, y compris peut
provoquer le fonctionnement indésirable de l'appareil.
Exposition aux rayonnements: Cet équipement est conforme aux
radiations du Canada limites d'exposition pour un environnement
incontrôlé noncé d'exposition RF Pour maintenir le respect des
guides d'exposition RF d'IC, cquipment doit être.installé et actionné
avec une distance minimale de 20cm le radiateur de votre corps.
Cet appareil et ses antennes ne doivent pas être co-localisé ou en
opération en conjonction avec toute autre antenne ou émetteur.

01
Contents
What In Box?
Mounting the Mirror
Mounting the rear camera
Mounting the GPS
Meeting Your T27
T27 Power Tools
Setting Up Your Camera
Playback your T27
Customizing Your T27
Parking Mode ( Optional )
GPS Player (PC)
Trouble Shooting
Customer Service
Product Information
03
04
06
10
12
14
15
17
19
25
27
29
30
32

02
NOTES
NOTES Before Installation
Do not directly plug and unplug the cable or SD card, please
perform related operations after camera off.
Do not expose to the sun for a long time is the best, camera will heat
on during its working, any damaged by high temperature will be
added to 1 year free replacement warranty.
Please use the cables and accessories provided in the package.
3OHDVHSOXJLQDOODFFHVVRULHVDQGSRZHUWKHGDVKFDPWRFRQŵUP
whether it can work well before installation.
If you encounter any problems, please feel free to contact our
customer service.

03
What In Box?
T27 Mirror Dash Cam
GPS Receiver
User Manual*1 Tool *1 Cleaning
Cloth *1 Cable Straps*5
Car Charger *1
Straps *4Backup Camera *1
Backup Camera
Cable *1
3M Sticker*1
Mount Bracket*1
Screws *4
(Inside of Vehicle)

04
Mounting the Mirror
Step 1: Pull out the lens of the T27 dash cam to match the rearview
mirror of the vehicle.
Step 2: Extend the straps around the back of the rear-view mirror
and attach them to the bottom retaining hooks.

05
Mounting the Mirror
Step 3: Power on the dash cam with box included car charger, don't
charge it with your own chargers.
Step 4: Test the camera to make sure everything works.

06
Mounting the rear camera
How to install the rear camera
We recommend installing the rear camera outside the car (above the
license plate). The effect of the rear camera inside the car may be
affected by the windshield.
1. Tear off the 3M adhesive of the rear camera (if you need to adjust
the angle of the camera, please stick the 3M adhesive on the iron
plate, if you don't need to adjust the angle, please stick it on the top
RIWKHUHDUFDPHUDDQGWKHQŵ[WKHUHDUFDPHUDLQWKHPRVWVXLWDEOH
position above the licence plate.
Rear Camera Upgrade
New rear camera comes with a mounting bracket which supports
both interior and exterior installation.
Adjustable angle
or
Inside the car bracket
Outside the car bracket
Fixed angle, not adjustable

07
Mounting the rear camera
2. Remove the Panel
Remove the inner panel of the trunk to
expose the rear wiring compartment of the
car. Open the trunk and look for a sturdy
inner panel covering the other side of the
license plate installation area. Then, insert
a decorative removal tool or another thin
device behind the panel and pry it apart.
3. Snake the cable
Use a trim removal tool to pop out tailgate
trim, then run the cable from outside of the
car into the trunk of your car.
4. After snaking your rear camera's
extension cable, connect the power cable
to your rear camera's extension cord.
NOTE:
If you need to install a trigger cable to activate the reversing guides,
SOHDVHŵQGWKHSRVLWLYHFDEOHRIUHYHUVLQJODPSDQGFRQQHFWWKHUHG
wire from the rear camera, you can also ask a professional for help.

08
Mounting the rear camera
How to install the rear camera in the car

09
NOTE:
If your car is a RV or a pickup truck, you can install the rear camera
forward (the bracket is below), and turn on the "Upside down of
rear camera" and turn off the "Rear Cam" Mirror Image" to adjust
the image.If you need a license plate bracket, we also provide this
accessory, feel free to CONTACT US.
Mounting the rear camera

10
Mounting the GPS
Installation location
Considering the use effect and installation convenience, we usually
UHFRPPHQGFXVWRPHUVLQVWDOOLWDWWKHSRVLWLRQVSHFLŵHGLQWKH
picture. Of course, you can also try to install it in other locations for
testing, and choose the location you think is most suitable.

11
Mounting the GPS
FAQ
Q: Why is my GPS not working? /How to use GPS ?
A: If you cannot receive the signal after inserting the GPS, please
follow the steps below.
1. The vehicle must be within a large area.
2. Insert the GPS plug again.
3. Place the GPS plug upward.
4. Restart
5. It will be recognized after about 40 seconds. If still cannot receive
the signal, it may be a GPS problem. Please CONTACT US and we
will help you solve this problem.

12
Meeting Your T27
NO. Name Description
Front Camera
GPS Port
Micro SD Card Slot
Rear Camera Port
Power Supply Port
Fasteners
Screen
Power Button
Record the front view of the vehicle.
Connect the GPS receiver.
Insert a Micro SD card (Preferably with a 128G SD card).
Connect the rear view camera.
Connect the car charger.
Please use the included silicone straps.
11.26 inch IPS touch screen.
Short press to turn off the screen, long
press to turn off the power.
1
2
3
4
5
6
7
8

13
Speed & Driving Direction: Once GPS is connected, the
information will show
Settings: Touch to enter the menu setting
File Playback: Playback the video & Photo
Start/ Stop Recording
Snapshot: Take a Snapshot
Date & Time
5HFRUGLQJ6WDWXV<HOORZŶDVKLQJPHDQV/RFN5HFRUGLQJ
Audio Record is on
Button's beep sound status
GPS Status: Once the GPS signal is successfully received, the
icon will turn GREEN. Otherwise, it turns WHITE.
Meeting Your T27

14
T27 Power Tools
1. Cig Charger
Note: It is best to use the power cord that comes with our products, or
our professional hardware kits.
Note: Not included, need to be purchased separately.
2. Hardwire Kit

15
Setting Up Your Camera
SD CARD
With your camera off, insert the SD card into the card slot with the
label facing the back of your camera.
<RXFDQHMHFWWKHFDUGE\SUHVVLQJLWLQWRWKHVORWZLWK\RXUŵQJHUQDLO
You'll need a micro SD card (sold separately) to save your videos and
photos. Use a U3 Class 10 SDTM Card dedicated or your camera may
malfunction.
SD cards can degrade over time and affect your camera's ability to
save your media. Try swapping out an older card for a new one if
you're having any problems.
WIRING SET UP
Connect your camera to a Cig charger using the included cig charge
cable.
UPDATING YOUR CAMERA'S SOFTWARE
To get the latest features and best performance from your camera,
make sure it's using the most current software.
Visit - KWWSVZZZUHGWLJHUFDPFRPSDJHVŵUPZDUH

16
Setting Up Your Camera
On the LEFT side of the screen: Slide up and down to adjust the
angle of view.
On the RIGHT side of the screen: Slide up and down to adjust the
brightness.
Anywhere on the screen: Swipe the screen left or right to switch
between front view, rear view, or split-screen view.