Redtiger T700 User manual

T700 USER MANUAL
Email: [e-mail]
Website: http://www.redtigercam.com
Phone: [phone]
V02

WARNING: Be careful when using your
camera and its accessories. Always be
cautious of your surroundings to avoid
injuring yourself and others.
Make sure to follow all local laws including
all privacy laws which may restrict recording
in certain areas.

IC warning:
This device contains licence-exempt transmitter(s)/receiver(s)/
that comply with Innovation Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the
following two conditions:
1. This device not cause interference.
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
Radiation Exposure: This equipment complies with Canada
radiation exposure limits set forth for an uncontrolled environment.
To maintain compliance with IC's RF Exposure guidelines, this
equipment should be installed and operated with minimum distance
of 20cm the radiator your body. This device and its antenna(s) must
not be co-located or operation in conjunction with anyother antenna
or transmitter.
Déclaration de l'ISED Canada:
Cet appareil contient des tasmittre (s) / récepteur (s) sans licence /
conformes à l'innovationRSS exemptes de licence de Sciences et
Développement économique Canada. L'opération est sous réserve
des deux conditions suivantes:
1. Cet appareil ne peut pas causer d'interférences et.
2. Cet dispositif doit accepter toute interférence, y compris peut
provoquer le fonctionnement indésirable de l'appareil.
Exposition aux rayonnements: Cet équipement est conforme aux
radiations du Canada limites d'exposition pour un environnement
incontrôlé noncé d'exposition RF Pour maintenir le respect des
guides d'exposition RF d'IC, cquipment doit être.installé et actionné
avec une distance minimale de 20cm le radiateur de votre corps.
Cet appareil et ses antennes ne doivent pas être co-localisé ou en
opération en conjonction avec toute autre antenne ou émetteur.

01
Contents
Mainten Your Camera
What's in the box?
Mounting the Mirror
Mounting the rear camera
Mounting the GPS
Meeting Your T700
T700 Power Tools
Setting Up Your Camera
Customizing Your T700
Redtiger Player ( PC )
Customer Service
Product Information
02
03
04
06
10
12
13
14
17
28
30
31

02
Mainten Your Camera
Do not directly plug and unplug the cable or SD card, please
perform related operations after camera off.
We do not encourage you connection your camera with other
hardwire kit, but if you insist to do this, please have a look of those
lower than 6V and higher than 3A.
Do not expose to the sun for a long time is the best, camera will heat
on during its working, any damaged by high temperature will be
added to 1 year free replacement warranty.

04
Mounting the Mirror
Step 1: Pull out the lens of the T700 dash cam to match the rearview
mirror of the vehicle.
Step 2: Extend the straps around the back of the rear-view mirror
and attach them to the bottom retaining hooks.

05
Mounting the Mirror
Step 3: Power on the dash cam with box included car charger, don't
charge it with your own chargers.
Step 4: Test the camera to make sure everything works.

06
Mounting the rear camera
How to install the rear camera
We recommend installing the rear camera outside the car (above the
license plate). The effect of the rear camera inside the car may be
affected by the windshield.
1. Tear off the 3M tape on the rear lens and
paste it above the license plate.
2. Remove the Panel
Remove the inner panel of the trunk to
expose the rear wiring compartment of the
car. Open the trunk and look for a sturdy
inner panel covering the other side of the
license plate installation area. Then, insert
a decorative removal tool or another thin
device behind the panel and pry it apart.
3. Snake the cable
Use a trim removal tool to pop out tailgate
trim, then run the cable from outside of the
car into the trunk of your car.
4. Connect the rear cameras power cable
to the extension cable. After snaking your
rear camera's extension cable, connect
the power cable to your rear camera's
extension cord.If you need to install a
trigger cable to activate the reversing
guidelines, please find the positive cable
of the reversing lamp or ask a professional
for help.

07
PLACEMENT OF REAR LENS INSIDE CAR
Mounting the rear camera
Step 1: Confirm the accessories
1 pc mount bracket (2 pcs black iron sheets)
4 pcs screws (2 pcs small screws, 2 pcs large screws)
Step 2: Place a iron sheet over the rear camera, aim it at the hole,
and screw it on.
Step 3: Join the two iron sheets together and turn on the screws.

08
Mounting the rear camera
Step 4:Stick the bracket to the rear windshield with 3M glue
NOTE:
1. We suggest to install outside the car, the effect inside the car is far
worse than outside the car.
2. If your car is a RV or a pickup truck, you can install the rear camera
forward (the bracket is below), and turn on the "Upside down of
rear camera" and turn off the "Rear Cam" Mirror Image" to adjust
the image.If you need a license plate bracket, we also provide this
accessory, feel free to CONTACT US.

09
Placement of rear cam outside car
We suggest to install outside car, not inside
Step 1: Tear off the release paper of 3M sticker on Rear lens.
Step 2: Paste the rear lens directly above the license plate.
Mounting the rear camera

10
Mounting the GPS
How to install the GPS
Installation location
Position 1: Considering that the front windshield of a motor vehicle
has a large enough view of the sky, it is usually recommended that
the GPS module be placed in the central console. At the corners of
the central console and the edge of the windshield, after adopting
hidden wiring, they are fixed with double-sided tape.
GPS front and back

11
Mounting the GPS
Considering the use effect and installation convenience, we usually
recommend customers to install it at position 1. Of course, you can
also try to install it in other locations for testing, and choose the
location you think is most suitable.
(1) Install the GPS Antenna onto the camera, the GPS Antenna will
start to search for a GPS signal.
(2) Once the GPS is installed, the GPS icon on the home screen will
show. After the GPS signal has been received, it will show direction
and speed. (Prerequisite: "GPS Disp" in the settings is turned on)

12
Meeting Your T700
NO. Name Description
Front Camera
Power Supply Port
Rear Camera Port
MicroSD Card Slot
GPS Port
Fasteners
Screen
Power Button
Record the front view of the vehicle
Connect the car charger
Connect the rear view camera
Insert aMicroSD card (maximum support 128G)
Connect the GPS receiver
Please use the included silicone straps
11 inch IPS touch screen
Short press to turn off the screen, long
press to turn off the power
1
2
3
4
5
6
7
8

14
Speed & Driving Direction: Once GPS is connected, the
information will show
Screen Brightness Adjustment: Slide the bar left and right to
adjust the screen brightness
Settings: Touch to enter the menu setting
File Playback: Playback the video & Photo
Start/ Stop Recording
Front / Rear View Switch: Switch between front view & rear
view
Snapshot: Take a Snapshot
Emergency Lock: Lock videos as event files so it won't be
overwrittenby loop recording
Date & Time
Recording Status: Yellow flashing means Lock Recording
Show SD card status
Audio Record is on
Loop Time: Adjust the loop recording duration
(1Min/2Min/3Min)
Setting Up Your Camera

15
Setting Up Your Camera
While recording, swiping the screen up and down adjusts the angle
of view.
While recording, swipe the screen left or right to switch between
front view, rear view, or split-screen view.
Touch the touchscreen to diaplay the brightness scrollbar at the
upper center, then slide right or left to adjust the brightness.

16
Setting Up Your Camera
SD CARD
With your camera off, insert the SD card into the card slot with the
label facing the back of your camera.You can eject the card by
pressing it into the slot with your fingernail.
WIRING SET UP
Connect your camera to a Cig charger using the included cig charge
cable.
You'll need a micro SD card (sold separately) to save your videos and
photos. Use a U3 Class 10 SD Card dedicated or your camera may
malfunction.
SD cards can degrade over time and affect your camera's ability to
save yourmedia. Try swapping out an older card for a new one ifyou're
havinganyproblems.