MILLI
LED MIRRORS
page 2 of 2
Please ensure a copy of the installation instructions is left
with the end user for future reference
Note
Wall materials vary. The accessory fixing kit supplied is suited for solid wall fixing. For timber framed
walls, please ensure the accessory is fixed to a noggin/stud behind the wall. Where stud/noggin is not
available, please use suitable hollow wall fixing.
MOUNTING INSTRUCTIONS
General description:
This magnifying mirror contains LED lights, a built-in battery charger and an
external power supply unit. The mirror can be turned on/off by a switch on
the rear side of the mirror. The magnifying mirror has the following features:
30 minutes automatic switch-off
Protection to avoid over charging and exhaustion
Fast charging batteries
Auto warning of low battery voltage
Switch on/off:
The mirror can be turned on and off by pressing the switch on the rear side
of the mirror. To turn off by pressing the switch, the light will slowly dim bofore
turning off completely.
The mirror has a timer set and will automatically turn off after 30 minutes.
Recharging batteries:
Plug in the power supply unit into the electrical port on the rear side of the
mirror at first, then plug it into an electrical socket.
The power supply
unit
and the battery port will get warm during charging
period.
The LED light will blink 3 times before the batteries are exhausted.
Unused rechargeable batteries will lose their charge over idle periods. To
avoid this problem, simply recharge unused batteries every two months in
order to assure maximum charge.
Loading/changing batteries:
In case that a rechargeable battery can no longer be fully
charged, disposal is recommended.
Please always use NiMH rechargeable batteries with
capacity 1600-2200mAh, Mignon (AA), same type
regarding capacity, producer etc.
To change the batteries, remove 3 screws on the rear
side of the mirror, carefully remove the front mirror with
acrylic frame. Attention! Please do not touch the LED strip!
Carefully place 6 rechargeable batteries in the appropriate +/- position, then
put the front mirror with acrylic frame and get it fixed by 3 screws on the rear
side of the mirror.
Attention! Please observe your local environmental regulations to dispose
the used batteries!
Technical data:
Voltage: 100-240V AC /50-60Hz
Battery: Mignon (AA), 1.2V / 1600-2000mAh,
6 pieces
Power supply unit: 12V DC 1000mA
Recharge time: 2-2.5 hours
Safe functioning temperature: 5-35°C
+-
Attention! Please charge the batteries for approx. 2.5 hours before first use.
General description:
This magnifying mirror contains LED lights, a built-in battery charger and an
external power supply unit. The mirror can be turned on/off by a switch on
the rear side of the mirror. The magnifying mirror has the following features:
30 minutes automatic switch-off
Protection to avoid over charging and exhaustion
Fast charging batteries
Auto warning of low battery voltage
Switch on/off:
The mirror can be turned on and off by pressing the switch on the rear side
of the mirror. To turn off by pressing the switch, the light will slowly dim bofore
turning off completely.
The mirror has a timer set and will automatically turn off after 30 minutes.
Recharging batteries:
Plug in the power supply unit into the electrical port on the rear side of the
mirror at first, then plug it into an electrical socket.
The power supply
unit
and the battery port will get warm during charging
period.
The LED light will blink 3 times before the batteries are exhausted.
Unused rechargeable batteries will lose their charge over idle periods. To
avoid this problem, simply recharge unused batteries every two months in
order to assure maximum charge.
Loading/changing batteries:
In case that a rechargeable battery can no longer be fully
charged, disposal is recommended.
Please always use NiMH rechargeable batteries with
capacity 1600-2200mAh, Mignon (AA), same type
regarding capacity, producer etc.
To change the batteries, remove 3 screws on the rear
side of the mirror, carefully remove the front mirror with
acrylic frame. Attention! Please do not touch the LED strip!
Carefully place 6 rechargeable batteries in the appropriate +/- position, then
put the front mirror with acrylic frame and get it fixed by 3 screws on the rear
side of the mirror.
Attention! Please observe your local environmental regulations to dispose
the used batteries!
Technical data:
Voltage: 100-240V AC /50-60Hz
Battery: Mignon (AA), 1.2V / 1600-2000mAh,
6 pieces
Power supply unit: 12V DC 1000mA
Recharge time: 2-2.5 hours
Safe functioning temperature: 5-35°C
+-
Attention! Please charge the batteries for approx. 2.5 hours before first use.
