Reece Milli EXO WALL BASIN SET 4 User manual

EXO WALL BASIN SET 4*
48
�







 







 




°








 
 
A3718
WM01455





page 1 of3
200mm
 

reece

SET OUT DISTANCE
Minimum 10mm
Maximum 22mm
40 to 52mm
FACTORY
POSITIONED
SEAL
Note: Always check the rubber seal on the ceramic
Cartridge is a round uniform shape. If distorted
push back into place or the cartridge will leak
when water is introduced.
Important: The patented seal design is factory set
in position and should not be moved prior to install.
TOOL
SUPPLIED
WRENCHING
FLATS
FACTORY
POSITIONED
SEAL
Important: Do not move/remove the factory set seal prior to installation.
Place each Ceramic cartridge with the factory set seal into the appropriate breech body.
Using the supplied tool, screw the cartridge in until the seat is reached and nip it up
until firm. (Recommended torque is 8N/m)
Screw the Lock Nut onto the Ceramic Cartridge and tighten using the opposite end of the
supplied tool until a watertight seal is reached. (Lock Nut recommended torque is 25N/m)
Check for water tightness before proceeding.
EXO WALL BASIN SET 4*

SECURE -FIT HANDLE
O-RING
HANDLE FITTING
HANDLE ORIENTATION
1. Separate parts from the handle as shown in
the illustration to the right.
2. Turn the ceramic cartridge to the off position.
3. Screw the Flange with O-ring onto the
cartridge lock nut until flush against the
finished wall.
4. Place the handle locking screw onto the
spindle, slotted side toward the wall.
5. Place the o-ring onto the retainer if not
already done so, then screw all the way
onto the spindle.
6. Place the spline adaptor onto the spindle
and against the retainer.
EXO WALL BASIN SET 4*