Rehab and Mobility Products RM400 User manual

Over Toilet Aids / Commodes
RM400
RM3327
RM406-65
RM371

RM Bathroom products come ready assembled.
Adjustment of the legs (if applicable)
Step 1: Using your thumb, push down the Push-
Pin and slide the leg up or down until the Push-
Pin clicks back into the location hole.
(In some cases there maybe a push-pin on either
side of the leg.)
Step 2: Ensure the Pin/s is completely through
the hole, and test to ensure the two pieces do
not come apart.
Step 3: Ensure all legs are adjusted to the same
height.
Assembly

It is important to never exceed this limit and always ensure that the
product weight capacity is sufficient before using the product. Failure
to do so could result in injury or damage the product.
Maximum User Weight
All of the product components are manufactured from high quality
materials. However, it is very important that you only clean your over
toilet aid or commode using a non-abrasive cleaner or mild detergent
with a soft cloth. Avoid using lime scale remover. Abrasive cleaners
and/or abrasive cleaning pads will seriously damage your product
beyond repair.
All Over Toilet Aids & Commodes should only be used for their
intended purpose.
All Over Toilet Aids & Commodes should be inspected regularly to
ensure moving components (push-pins, seats) remain secure. If in
doubt, do not use and immediately contact your supplier for support.
Your safety is of the utmost importance.
Care & Maintenance
Product Code Description Weight Limit
RM400 Over Toilet Aid 160kg
RM406-65 Bariatric Over Toilet Aid 305kg
RM3327 Bariatric Static Commode 226kg
RM371 Combination Over Toilet Aid / Shower Chair 227kg

Your Local Dealer:
Imported by
Rehab and Mobility Wholesalers Pty Ltd
P: 1300 368 085
E: [e-mail]
www.rehabandmobility.com.au
Warranty
All products carry a 12 month warranty from the date of
purchase against manufacturing defects.
Misuse or Damage is not covered.
This warranty does not affect your statutory rights.