Rehab and Mobility Products RM440 User manual

Adjustable Toilet Seat
Raiser
RM440

Step 1 Remove existing toilet seat from
the bowl.
Installation
Step 2 Position the unit onto your toilet
bowl, inserting the rear mounting bolts
through the existing holes on your toilet.
Step 3 The position of the mounting bolts can be adjusted to match different
toilets. To adjust, loosen & slide the mounting bolts along the rear bar to
achieve the correct distance. Reattach nuts and tighten firmly. Ensure toilet
seat raiser is firmly clamped against the bowl before use.
Adjusting seat height
The toilet seat raiser can be adjusted to 3 different height settings, adding 50,
100 or 150mm to the height of the bowl. Height can be adjusted either before
or after installation.
Bolt protector
Flip up the toilet seat for easy access to the bars.
To adjust the height, undo the front thumb screw
bolts, reposition the bar to the desired height and
reinsert the thumb screw bolts on both sides and
tighten until firm.
Adjust the rear bar in the same way. Adjustment can
be made to facilitate a forward angled tilt for users
requiring extra assistance when standing (rear bar
lower than the front bar).
When adjustment is complete, replace all thumb
screw bolt protector caps if the unit is supplied with
alternative bolt and cap combinations.

Maximum User Weight
All of the product components are manufactured from high quality materials.
However, it is very important that you only clean your toilet seat raiser using a
non-abrasive cleaner or mild detergent with a soft cloth. Abrasive cleaners
and/or abrasive cleaning pads will seriously damage your product beyond repair.
Regularly check the mounting screws are tight and that the toilet seat raiser is
firmly clamped to the toilet bowl. Do Not use if the seat is cracked or deformed in
any way.
Care & Maintenance
It is important to never exceed this limit and always ensure that the
product weight capacity is sufficient before using the product. Failure to
do so could result in injury or damage the product.
Product Code Description Weight Limit
RM440 Toilet Seat Raiser 136kg
Ideal Seat Height
Ideal height is when the user’s
feet are flat on the floor, hip
height is higher than knee
height (ie less than 90 degrees
on the knee joint or hip joint)
Inserting Armrests
The toilet seat raiser can be used with or without
armrests. One or both armrests can be used to
suit individual user. A brass locking button is used
to secure each arm.
Insert the armrest by pressing the locking button
located under the frame of the armrest and slide
the armrest into the arm hole at the side of the
toilet seat. Ensure secure before use.
NB: The toilet seat raiser operates just like a standard toilet seat. The seat may
be flipped up so the bowl can be accessed without the seat.

Your Local Dealer:
Imported by
Rehab and Mobility Wholesalers Pty Ltd
P: 1300 368 085
E: [e-mail]
www.rehabandmobility.com.au
Warranty
All products carry a 12 month warranty from the date of
purchase against manufacturing defects.
Misuse or Damage is not covered.
This warranty does not affect your statutory rights.