Remington PURE CONFIDENCE User manual

2 YEAR WARRANTY WR1000AU
PURE CONFIDENCE
LADY SHAVER
To register your product go to
www.remington-products.com.au
www.remington.co.nz
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE

2
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should
always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
DANGER: As with most electrical appliances, electrical parts are
electrically live even when the switch is off.
For additional protection, the installation of a residual current
device (rcd) having a rated residual operating current not
exceeding 30 mA is advisable in the electrical circuit supplying
the bathroom. Ask your installer for advice.
WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION AND
FIRE OR INJURY TO PERSONS.
• The appliance should never be left unattended when plugged into a
power outlet, except when charging the appliance.
• This appliance should not be used by children or other persons with
reduced physical, sensory or mental capabilities or lack of experience
and knowledge unless they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the
hazards involved.
• Children shall not play with the appliance.
• Cleaning and use maintenance shall not be made by children without
supervision.
• Never operate this appliance if it has a damaged cord or plug, if it is
not working correctly, if it has been dropped or damaged, or dropped
into water. If the supply cord or plug of the appliance is damaged it
must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard. It cannot be repaired.
• Keep the cord away from heated surfaces.
• Charge, use and store the product at a temperature between 0°C and
32°C.
• Do not use outdoors or where aerosol (spray) products are being used,
or where oxygen is being administered.
• Do not use this appliance with damaged or broken tracks or cutters, as
injury may occur.
• Do not plug or unplug the appliance with wet hands.
• For household use only.

3
• Do not place or store the appliance or charging adaptor where it can
fall or be knocked into a sink or bath.
• Do not place in or drop into water or any other liquid.
• If an appliance falls into water, “unplug it” immediately. Do not reach
into the water.
• Unplug the charging adaptor from the electrical outlet immediately after
fully charging.
• Unplug the power adaptor from the appliance before cleaning the
appliance in water.
• Use this appliance only for its intended use as described in this
manual.
• Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this appliance.
• Always store the charging adaptor in a moisture-free location.
• Do not use on people who are asleep.
• Do not use an extension cord or a voltage converter with this
appliance.
• Do not wrap the cord around the appliance.
• Remington strongly recommends that an approved Safety Switch
(residual current device) be installed to protect all bathroom power
outlets. Ask an electrical contractor for advice.
SAVE THESE INSTRUCTIONS

4
WR1000AU PURE CONFIDENCE LADY SHAVER
USE & CARE INSTRUCTION MANUAL
Thank you for purchasing your new Remington®Pure Confidence Lady
Shaver. Inside this manual you will find tips on using and caring for your
shaver.
KEY PARTS
1. On/Off Switch
2. Shaving Heads
3. 360° Pivoting Neck
4. LED Battery Indicators
5. Charging Pins
6. Massaging Brush
7. Brush Mount
8. Exfoliating Brush
Also Includes:
• Head Guard
• Storage Bag
• Cleaning Brush
• Power Adaptor
1
4
58
3
6
7
2

5
WR1000AU SPECIFICATIONS
Power System Cordless (Rechargeable)
Full Charge Time 4 Hours
Cordless Run Time Up to 60 Minutes
Indicators LED Battery Indicators
Voltage Type Worldwide 100 - 240V
Replacement Head & Cutters SPR-WR1000AU
Power System: The WR1000AU shaver can only be used without the
power cord. The shaver will not run while it is charging.
LED Battery Indicators: Lights display the battery charge level
• Low Charge: Top LED light will glow solid red to indicate the shaver
needs to be recharged. There is less than 5 minutes of run time
remaining.
• Charging: Bottom LED light will glow solid green to indicate the
battery is taking a charge.
• Full Charge: When fully charged the green LED light will go off.
Worldwide Voltage: Shaver automatically adapts to an outlet voltage
between 100V and 240V.
Note: Some countries will require the use of a plug adaptor that is not
included with your shaver.
CHARGING
1. Plug power cord adaptor into the shaver.
2. Plug the adaptor into the wall outlet.
3. Fully charge your shaver for 4 hours before its first use. This first
charge is important to the shaver’s battery life.
Note: During the initial charge ignore the electronic indicators as they are in
“Start Up Cycle”.
Caution:
• Make sure the shaver and your hands are dry when charging the
shaver.
• Always charge the shaver in a cool, dry place.

6
CHANGING THE ATTACHMENTS
1. The unit should be turned off when changing attachments.
2. Remove the attachments by lifting upward from the base.
3. Align the hexagon shapes of the base and brush mount and press to
snap the brush mount onto the base.
4. Snap the massaging or exfoliating brush onto the brush mount.
MASSAGING BRUSH - PRE-SHAVE
Use the silicone massaging brush to exfoliate the skin and lift hairs for an
extra close shave.
1. Dampen the silicon pre-shave massage brush.
2. Press On/Off button to turn on.
3. While applying gentle pressure, move the rotating brush in circular
motions over the desired area.
EXFOLIATING BRUSH
1. Moisten the brush bristles by running under water.
2. Press On/Off button to turn on.
3. While applying gentle pressure, move the rotating brush in circular
motions over the desired area.
SHAVING
1. Press power button to turn on.
2. Shave desired areas using short, circular strokes.
3. After shaving, turn the shaver off.
SHAVING TIPS WITH GEL OR FOAM (IN SHOWER OR OVER THE SINK)
Remington®Pure Confidence Lady Shaver is waterproof. You may use
shaving foam or gel with your shaver. We recommend that you use the
shaver in the shower for optimal performance.
1. Apply water to desired shaving area.
2. Apply shaving cream to desired shaving area.
3. Rinse shaver head under water.
4. Shave using short, circular strokes.
5. Throughout the shave, regularly rinse the shaver head under water to
avoid residue build up.

7
6. When finished shaving, rinse shaved area.
7. Thoroughly rinse shaver head of all gel or foam.
8. Follow cleaning instructions.
Note: In order to ensure optimal performance, thoroughly rinse the shaver
under water during and after shaving. This will avoid having the foam or gel
dry in the cutting head and clogging the shaver.
SHAVING TIPS (DRY)
• Always hold the shaver at a right angle to the skin so that all three
heads are touching the skin with equal pressure.
• Stretch skin with free hand so hairs stand upright, making it easier for
them to enter the cutting chamber.
• Use moderate to slow, circular stroking movement.
• The use of short, circular motions in stubborn areas may obtain a
closer shave.
• Do not press hard against the skin to avoid skin irritation and / or
damage to the rotary heads.
CLEANING & MAINTENANCE
Note: When cleaning your shaver, make sure the shaver is turned off and
disconnected from the power cord.
The shaver is a washable appliance. The head and body may be cleaned
under warm water.
Caution:
• When cleaning the external surfaces of the shaver, do not use strong
detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a
hair dryer or heater to dry the shaver.
Note: The shaver head and neck assembly is designed to be detachable
from the shaver body. Simply pull upwards from the neck of the shaver for
easy release. To reattach the neck, align it with the neck attachment cavity
so that it clips back into position.

8
Cleaning Your Shaver
Daily Cleaning
1. Locate the detachment grooves on the head & cutter assembly. Gently
pull to detach the hair pocket from the neck assembly (Diagram A).
2. Tap out excess hair shavings (Diagram B).
3. Rinse the head of the shaver in running water.
4. Gently reattach the hair pocket to the neck assembly until it locks in
place on all three sides. The hair pocket may be reattached in any
configuration (Diagram G).
SHAVER PARTS
1. Head & cutter (hair pocket)
assembly
2. Detachment grooves
3. Neck assembly
4. Neck attachment cavity
1234
LMNO
Q
P
LMNO
Q
P
LMN
O
Q
P
L
MNO
Q
P
C
L
M
NO
Q
P
LM
N
O
Q
P
AB
F
C
G
D
E

Article Price each
AUD
Price each
NZD Qty Amount
$
SP4 $
$ $ $
Sub Total
Postage &
handling
TOTAL
7.50
R Shaver Saver: Aerosol Spray Cleaner
eplacement Shaving Heads & Cutters for WR1000AU SPR-WR1000AU
$11.95 AUD $29.95 AUD
$14.95 NZD $34.95 NZD
Remington is a Registered Trademark of Spectrum Brands, Inc., or one of its subsidiaries.