
V850ES/HG3 ターゲット・ボード
QB-V850ESHG3-TB ユーザーズ・マニュアル
ユーザーズ・マニュアル
R20UT2632XJ0100
Rev 1.00 2013.5.17
本製品は、ルネサス エレクトロニクス製のプログラミング機能付きオンチップ・デバッグ・エミュレータ QB-MINI2(以下 MINICUBE2)を使用
して、マイコンの動作を試すためのターゲット・ボードです。
①V850ES/HG3 ターゲット・ボード(QB-V850ESHG3-TB)の特徴
●V850ES/HG3(μPD70F3752GC)搭載
●メイン・クロック 8MHz(発振子を搭載)で最大 32MHz で動作可能(4.0V~5.5V 供給時)
●ユニバーサル・エリア(2.54mm ピッチ)を搭載
●フラッシュ・メモリ・プログラミング、オンチップ・デバッグ(SIB0,SOB0,SCKB0,PCM0 端子使用)に両対応
●マイコンの端子を周辺ボード・コネクタに配置した高拡張性
●鉛(Pb)フリー対応品
②V850ES/HG3 ターゲット・ボード(QB-V850ESHG3-TB)のハードウエア仕様
メイン・クロック動作周波数 最大 32MHz(ボード上に発振子 8MHz 搭載)
CPU
μPD70F3752GC サブクロック動作周波数 32.768KHz(ボード上に搭載)
CN1,CN2: 周辺ボードコネクタ(2.54mm ピッチ) 50pin ソケット x2(パッドのみ)
CN3: 16pin コネクタ(MINICUBE2 接続用)
PowerLED: 赤 x1(LED3)
評価用 LED: 黄 x2(LED1 は PCM3,LED2 は PCM2 へ接続)
評価用 SW: SW1(INTP0 へ接続)
メイン・クロック(OSC): 8MHz 発振子(X1,X2 へ接続)
搭載部品
サブクロック(OSC2): 32.768KHz 発振子(XT1,XT2 へ接続)
動作電圧 4.0V~5.5V
③寸法、部品配置など
71.00mm
55.88mm
GND
V850ES
/HG3
TXDD0
SOB0
SIB0
RXDD0
SCKB0
HS
評価用LED
上:LED2
下:LED1
CN1
16pinコネクタ
デバッグ設定用
ショートパッド
サブクロック
ユニバーサル
・エリア
Power LED
CN2
メイン・クロック
50
49
2
1
LED2
PCM2
PCM3
OCD/Flash Program
1
15
50
1
2
49
QB-V850ESHG3-TB(e)
SS-77063-2
RoHS
compliant
CN2
CN1
SW1
LED3
45.72mm
LED1
VDD OSC2
OSC
※1
評価用SW
CN3
基板上のパターン について:パターンをカットすることで、その回路はオープンとなります。
再度接続させたい場合は半田ショートしてください。
PCM2,PCM3 を使用する場合は LED の左隣のショートパッドをパターンカットしてください。
※1 オンチップ・デバッグ接続方式を変更できます。デバッグ設定用ショートパッドを下表のように設定してください。
接続方法 ショート オープン
CSI0(デフォルト) SOB0, SIB0, SCKB0, HS TXDD0, RXDD0
UART0 TXDD0, RXDD0 SOB0, SIB0, SCKB0, HS
④使用上の注意
・本製品に関してのサポートはお受けしておりません。初期不良の場合に限り、交換いたします。
・本製品を MINICUBE2 へ接続する場合は電源選択スイッチを「5」または「T」で使用してください。
R20UT2632XJ0100Rev.1.00 Page 1 of 2
2013.5.17
V850ES/HG3 Target board
QB-V850ESHG3-TB User’s Manual
User’s Manual
R20UT2632XJ0100
Rev 1.00 2013.5.17
The QB-V850ESHG3-TB is a target board used for evaluating microcontroller operations, using the QB-MINI2, the Renesas
Electronics on-chip debug emulator with programming function (hereinafter referred to as MINICUBE2).
(1) V850ES/HG3 target board (QB-V850ESHG3-TB) features
●Incorporates V850ES/HG3 (μPD70F3752GC)
●A 8 MHz resonator mounted as main clock, high-speed operation enabled at 32 MHz
●Equipped with universal area (2.54 mm pitch)
●Supports both flash memory programming and on-chip debugging (using SIB0, SOB0, SCKB0 and PCM0 pins)
●Highly extendable; peripheral board connectors are equipped with microcontroller pins
●Lead-free (Pb-free) product
(2) V850ES/HG3 target board (QB-V850ESHG3-TB) hardware specifications
Main clock operating frequency 32 MHz max. (8MHz resonator mounted on board)
CPU
μPD70F3752GC Subclock operating frequency 32.768 KHz (mounted on board)
CN1, CN2: Peripheral board connectors (2.54 mm pitch), 50-pin socket 2 (pad only)
CN3: 16-pin connector (for MINICUBE2 connection)
Power LED: Red 1 (LED3)
Test LED: Yellow 2 (LED1 connected to PCM3, and LED2 connected to PCM2)
Test SW: SW1 (connected to INTP0)
Main clock (OSC): 8 MHz resonator (connected to X1 and X2)
Embedded parts
Subclock (OSC2): 32.768 KHz resonator (connected to XT1 and XT2)
Operating voltage 4.0 to 5.5 V
(3) Dimensions and parts layout
71.00mm
55.88mm
45.72mm
LED3
GND
PCM3
PCM2
V850ES
/HG3
OSC
RoHS
compliant
SOB0
SIB0
RXDD0
SCKB0
HS
CN1
Sub Clock
16pin connector
Short Pad for
debug setting
Test LED
upper:LED2
lower:LED1
LED2
50
49
2
1
CN1
SW
1
1
2
QB-V850ESHG3-TB(e)
SS-77063-2
CN2
50
49
OSC2 15
1
OCD/Flash Program
LED1
Test SW
Main Clock
VDD
Power LED
CN2
Universal
area
Note
TXDD0
CN3
Pattern on the board: Splitting this wiring leaves open the relevant circuit ( ).
To reconnect the circuit, short the circuit by soldering ( ).
When using PCM2 and PCM3, cut off the short pad on the left side of LED.
Note: Connected method when on-chip debugging it by setting a short pad can be changed.
Connection method Short Open
CSI0(Default) SOB0, SIB0, SCKB0, HS TXDD0, RXDD0
UART0 TXDD0, RXDD0 SOB0, SIB0, SCKB0, HS
(4) Notes on use
●Renesas Electronics will not provide any support for this board, but the board can be exchanged with a new product only when
it has an initial failure.
●Please set the power supply selection switch to [5] or [T] when you connect this board with MINICUBE2.
R20UT2632XJ0100 Rev.1.00 Page 1 of 2
2013.5.17