5
INSTALLATION OPTIONS
Depending on your requirements, you can either mount the Sense GO on the wall or stand it up some-
where.
1. Free-standing installation
The Sense GO’s compact design and
the handy tabletop tool make this in-
door air quality monitor ideal to take
with you wherever you go. The Sense
GO can fit on practically any table,
cabinet, desk, etc.
Slide the bracket onto it at the back
of the housing and place the monitor
on a flat and dust-free surface.
For the most accurate measure-
ments, it is recommended to place
the device in the ‘breathing zone’ i.e.
between 70 centimetres and 1.8 m
from the ground, in a central location
in a dry, well-ventilated space.
Ensure that the monitor is stable
and that no objects interfere with the
penetration of CO2into the monitor.
2. Wall installation
If your preference goes to a
wall-mounted Indoor Air Quality
monitor, follow next steps to mount
your Sense GO:
1. Use the accompanying position-
ing mark to easily attach your
Sense GO to the wall at the de-
sired height.
40 mm
2. Using the positioning mark, drill
two holes in the wall with a 5 mm
diameter screw.
When drilling, make sure that you
do not touch any important wires
and keep your Sense GO away
from the dust.
3. Push the plastic attachments
into the drilled holes and screw
the screws in until they stick out
about 5 mm.
4. Your Sense GO can be easily af-
fixed to the protruding screws.
